Dell External M1000e t Getting Started Guide

Dell External M1000e t Manual

Dell External M1000e t manual content summary:

  • Dell External M1000e t | Getting Started Guide - Page 1
    Dell PowerEdge M1000e, M915, M910, M820, M710HD, M710, M620, M610x, M610, M520, and M420 Getting Started Guide Regulatory Model: BMX01, DWHH, HHB, FHB, and QHB Regulatory Type: DWHH Series, HHB Series, FHB Series, and QHB Series
  • Dell External M1000e t | Getting Started Guide - Page 2
    tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2012 Dell Inc. Trademarks used in this text: Dell™, the Dell logo, Dell Precision™ , OptiPlex™, Latitude™, PowerEdge™, PowerVault™, PowerConnect™, OpenManage™, EqualLogic
  • Dell External M1000e t | Getting Started Guide - Page 3
    And Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the blade server or enclosure. Unpacking The System Unpack your blade server or enclosure and identify each item. Installing The Rails And Enclosure Figure 1. Installing the Enclosure
  • Dell External M1000e t | Getting Started Guide - Page 4
    cover on the sleeve handle after the sleeve is installed in the enclosure. Reinstall the cover only if the sleeve is not installed in the enclosure. Installing A Quarter-Height Blade In A Sleeve CAUTION: Install a blade blank in all empty blade slots to maintain proper thermal conditions. Slide the
  • Dell External M1000e t | Getting Started Guide - Page 5
    the blades into the enclosure from left to right. When the blade is securely installed, the blade handle returns to the closed position. Connecting The CMC And iKVM Modules Figure 5. Connecting the Modules Connect the serial cable and network cable(s) from the management system to the CMC module
  • Dell External M1000e t | Getting Started Guide - Page 6
    , a minimum of three power supplies are required. Plug the other end of the power cables of the AC power supplies into a power distribution unit (PDU). For DC power supplies, plug the other end of the power cables to a branch-protected DC power source. NOTE: The power supply units must have the same
  • Dell External M1000e t | Getting Started Guide - Page 7
    describes how to troubleshoot the system and install or replace system components. This document is available online at support.dell.com/manuals. • For the Owner's Manuals and Installation Guides for Dell EqualLogic hardware, go to support.equallogic.com. • The rack documentation included with your
  • Dell External M1000e t | Getting Started Guide - Page 8
    , drivers, and systems management firmware on your system from support.dell.com. Obtaining Technical Assistance If you do not understand a procedure in this guide or if the system does not perform as expected, see your Owner's Manual. Dell offers comprehensive hardware training and certification
  • Dell External M1000e t | Getting Started Guide - Page 9
    240 V AC, 50 Hz/60 Hz (2700 W power supply) DC/DC power supply (per power supply module) Wattage Connector Heat dissipation Maximum inrush current System Voltage Requirements 2700 W Molex # 394260002 at PSU end, mating connector Molex # 39422-0012 1205 BTU/hr (maximum) Under typical input voltage
  • Dell External M1000e t | Getting Started Guide - Page 10
    and M610x Height Width Depth Weight (maximum) PowerEdge M710HD and M620 Height Width Depth Weight (maximum) PowerEdge M610 Height Width Depth Weight (maximum) PowerEdge M520 Height Width Depth Weight (maximum) PowerEdge M420 Sleeve Height Width Depth Weight Blade Height Width Depth 10 38.5 cm (15
  • Dell External M1000e t | Getting Started Guide - Page 11
    Physical - Blades Weight (maximum) 2.3 kg (5.07 lb) Physical - Enclosure Height Width Depth Weight (maximum) Weight (empty) 44.0 NOTE: For information on supported expanded operating temperature range and configurations, see support.dell.com/manuals. Storage Relative humidity Operating Storage
  • Dell External M1000e t | Getting Started Guide - Page 12
    Environmental Storage Airborne contaminant level Class NOTE: For altitudes above 2950 ft, the maximum operating temperature is derated 1 ºF per 550 ft. -15.2 m to 10,668 m (-50 ft to 35,000 ft) G1 as defined by ISA-S71.04-1985 12
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

Dell PowerEdge M1000e, M915, M910, M820, M710HD,
M710, M620, M610x, M610, M520, and M420
Getting Started Guide
Regulatory Model: BMX01, DWHH, HHB, FHB, and QHB
Regulatory Type: DWHH Series, HHB Series, FHB Series, and QHB
Series