Dell Latitude E6400 Replacing the Bottom Access Panel

Dell Latitude E6400 Manual

Get Dell Latitude E6400 PDF manuals and user guides View all Dell Latitude E6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Dell Latitude E6400 manual content summary:

  • Dell Latitude E6400 | Replacing the Bottom Access Panel - Page 1
    bottom access-panel from your computer (see your Service Manual). NOTE: If the original iAMT configuration-mode label is missing, damaged, or otherwise illegible, contact Dell to obtain your iAMT configuration-mode number (see your Setup and Quick Reference Guide for contact information). June 2008
  • Dell Latitude E6400 | Replacing the Bottom Access Panel - Page 2
    the matching location on the new bottom access panel. 5 Replace the bottom access panel (see your Service Manual). Information in this document is subject to change without notice. © 2008 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written
  • 1
  • 2
Replacing the Bottom Access Panel
About Cautions
CAUTION:
A CAUTION indicates a potential for property damage, personal injury,
or death.
CAUTION:
Before you begin any of the procedures in this section, read the safety
information that shipped with your computer. For additional safety best practices
information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTICE:
If you need to remove the computer cover, first disconnect the computer
power and modem cables from all electrical outlets.
To replace the bottom access panel of your computer, you need the
iAMT configuration-mode number that is located on the original bottom
access-panel of your computer.
Follow the instructions on this tech sheet carefully to ensure that you:
•
Remove the original bottom access-panel from your computer (see your
Service Manual
).
•
Select the correct label that is provided in the replacement kit.
•
Install the label in the correct location on the replacement
bottom
access-panel
.
To replace the bottom access panel:
1
Remove the original bottom access-panel from your computer (see your
Service Manual
).
NOTE:
If the original iAMT configuration-mode label is missing, damaged,
or otherwise illegible, contact Dell to obtain your iAMT configuration-mode
number (see your
Setup and Quick Reference Guide
for contact information).
June 2008