Dell PowerConnect 2848 User's Guide - Page 32
Connecting the Device, Connecting the Device to the Network - configuration
View all Dell PowerConnect 2848 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
6 On the wall mark the locations where the screws to hold the device must be prepared. 7 On the marked locations, drill the holes and place all plugs (not provided) in the holes. 8 Secure the device to the wall with screws (not provided). Ensure that the ventilation holes are not obstructed. Figure 3-3. Mounting Device on a Wall Connecting the Device To configure the device, the device must be connected to a terminal. Connecting the Device to the Network To connect to an uplink port, use Category 5 Unshielded Twisted-Pair (UTP) cables with RJ-45 connectors at both ends. The RJ-45 ports on the Ethernet device support automatic Media-Dependent Interface/Media-Dependent Interface with internal crossover wiring (MDI/MDIX) operation under Auto-Negotiation mode. Standard straight-through twisted-pair cables can be used to connect to any other Ethernet network (systems, servers, switches or routers) that supports auto-negotiation. 32 Dell PowerConnect 28xx Systems User Guide