Dell PowerConnect 7024 Getting Started Guide - Page 27

• Allows you to specify the network management system IP address or permit management access from all IP addresses. • Configures the default gateway IP address for the VLAN 1 interface. Example Session This section describes an Easy Setup Wizard session. The following values are used by the example session: • The SNMP community string to be used is public. • The network management system (NMS) IP address is 10.1.2.100. • The user name is admin, and the password is admin123. • The OOB management interface uses DHCP for IP address assignment. • The IP address for the VLAN 1 routing interface is 10.1.1.200 with a subnet mask of 255.255.255.0. • The default gateway is 10.1.1.1 The setup wizard configures the initial values as defined above. After completing the wizard, the switch is configured as follows: • SNMPv2 is enabled and the community string is set up as defined above. SNMPv3 is disabled by default. • The admin user account is set up as defined. • A network management system is configured. From the management station, you can access the SNMP, HTTP, and CLI interfaces. You may also choose to allow all IP addresses to access these management interfaces by choosing the (0.0.0.0) IP address. • DHCP is enabled on the OOB management interface. • An IP address is configured for the VLAN 1 routing interface. • A default gateway address is configured. NOTE: In the example below, the possible user options or default values are enclosed in [ ]. If you press with no options defined, the default value is accepted. Help text is in parentheses. Getting Started Guide 25