Dell PowerConnect Brocade 300 Fabric OS Administrator's Guide v7.1.0 - Page 217

IP Filter policy 7 Starting FCAP authentication 1. Log in to the switch using an account with admin permissions, or an account with OM permissions for the Authentication RBAC class of commands. 2. Enter the authUtil --authinit command to start the authentication using the newly imported certificates. (This command is not supported in Access Gateway mode.) 3. Enter the authUtil --policy -sw command and select active or on, the default is passive. This makes the changes permanent and forces the switch to request authentication. (For Access Gateway mode, the defaults for sw policy and dev policy are off, and there is no passive option for sw policy.) NOTE This authentication-policy change does not affect online EX_Ports. Fabric-wide distribution of the authorization policy The AUTH policy can be manually distributed to the fabric by command; there is no support for automatic distribution. To distribute the AUTH policy, see "Distributing the local ACL policies" on page 227 for instructions. Local Switch configuration parameters are needed to control whether a switch accepts or rejects distributions of the AUTH policy using the distribute command and whether the switch may initiate distribution of the policy. To set the local switch configuration parameter, refer to "Policy database distribution" on page 224. NOTE This is not supported for Access Gateway mode. IP Filter policy The IP Filter policy is a set of rules applied to the IP management interfaces as a packet filtering firewall. The firewall permits or denies the traffic to go through the IP management interfaces according to the policy rules. Fabric OS supports multiple IP Filter policies to be defined at the same time. Each IP Filter policy is identified by a name and has an associated type. Two IP Filter policy types, IPv4 and IPv6, exist to provide separate packet filtering for IPv4 and IPv6. It is not allowed to specify an IPv6 address in the IPv4 filter, or specify an IPv4 address in the IPv6 filter. There can be up to six different IP Filter policies defined for both types. Only one IP Filter policy for each IP type can be activated on the affected management IP interfaces. Audit messages will be generated for any changes to the IP Filter policies. The rules in the IP Filter policy are examined one at a time until the end of the list of rules. For performance reasons, the most commonly used rules should be specified at the top. On a chassis system, changes to persistent IP Filter policies are automatically synchronized to the standby CP when the changes are saved persistently on the active CP. The standby CP will enforce the filter policies to its management interface after policies are synchronized with the active CP. Fabric OS Administrator's Guide 217 53-1002745-02