Dell PowerConnect W-AP175 Dell PowerConnect W-AP175P Installation Guide - Page 15
Weatherproofing Directly Connected Antennas, First Wrapping of Tape,
View all Dell PowerConnect W-AP175 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Weatherproofing Directly Connected Antennas First Wrapping of Tape 1. Before wrapping the antennas, locate the weep holes (Figure 6). Weep holes allow condensation that has built up inside the antenna to escape. 2. Prepare the antenna connector by cleaning and drying it. 3. Cut a 4" (100 mm) strip of electrical tape from the roll. Pre-cutting the tape into strips makes in easier to maneuver the tape around the antennas and other components of the AP's case. 4. Beginning just below the weep holes, tightly wrap the connection with a layer of the 3/4" (19mm) electrical tape. Overlap the tape to a half-width. 5. Repeat steps 3 and 4 until the wrapping extends all the way to the AP's case. Figure 8 First Wrapping of Tape Pieces of tape as needed Wrap tape from just above knurled section to base of antenna mount Leave weep holes uncovered AP175_12 Dell PowerConnect W-AP175 Outdoor Access Point | Installation Guide 15