Dell PowerEdge 2650 Cabling Instructions for the –48 VDC
Dell PowerEdge 2650 Manual
View all Dell PowerEdge 2650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerEdge 2650 manual content summary:
- Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 1
Dell™ Systems Cabling Instructions for the -48 VDC www.dell.com | support.dell.com - Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 2
to hardware or loss of data and tells you how to avoid the problem. CAUTION: A CAUTION indicates a potential for property damage, personal injury the entities claiming the marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other - Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 3
requirements and wiring instructions for a -48 VDC power cable and safety ground wire for systems equipped with a -48 VDC power supply. CAUTION: A qualified electrician must perform all connections to DC power product is intended for restricted access locations (dedicated equipment rooms, equipment - Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 4
www.dell.com | support.dell.com Input Requirements Supply voltage: Current consumption: -(48-60) VDC 8 A Kit Contents • AMP 794949-1 connector housing, or equivalent • AMP 350218-1 connector contacts, or equivalent • AMP 2-36161-5 ring-tongue terminal, or equivalent • #6-32 nut equipped with - Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 5
: 1 Strip the insulation from the ends of the six DC power wires, exposing approximately 4.5 mm (0.175 inches) of copper wire. 2 Using a hand-crimping tool, crimp a connector contact to each DC power wire. 3 Slide a piece of heat-shrink tubing over the DC power cable. The heat-shrink tubing should - Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 6
| support.dell.com Assembling the Safety Ground Wire 1 Strip the insulation from the end of the green/yellow wire, exposing approximately 4.5 mm (0.175 inches) of copper wire. 2 Using a hand-crimping tool, crimp the ring-tongue terminal to the green/yellow wire. Connecting the -48 VDC Power Cable - Dell PowerEdge 2650 | Cabling Instructions for the –48 VDC - Page 7
- Dell PowerEdge 2650 | Cabling
Instructions for the –48 VDC - Page 8
Printed in the U.S.A. 00R216A00 P/N 0R216 Rev. A00 www.dell.com | support.dell.com
www.dell.com | support.dell.com
Dell™ Systems
Cabling Instructions for
the °48 VDC