Dell PowerEdge 2950 Cabling Instructions for the -48 VDC Power Supply
Dell PowerEdge 2950 Manual
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerEdge 2950 manual content summary:
- Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 1
Dell™ PowerEdge™ 2950 Systems Cabling Instructions for the -48 VDC Power Supply Dell™ PowerEdge™ 2950 系统 有关 -48 VDC www.dell.com | support.dell.com - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 2
- Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 3
Dell™ PowerEdge™ 2950 Systems Cabling Instructions for the -48 VDC Power Supply www.dell.com | support.dell.com - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 4
either potential damage to hardware or loss of data and tells you how to avoid the problem. CAUTION: A CAUTION indicates a potential for property permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of Dell Inc. Other - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 5
earthing conductor at the equipment. See installation instructions. This equipment is designed to permit wiring must comply with applicable local or national codes and practices. CAUTION: The system chassis must . CAUTION: When stranded wiring is required, use approved wiring termination, such as - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 6
installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Input Requirements washer (1) Required Tools • 10 AWG, 2 m maximum green, stranded wire (optional connector ground) • One UL 1015 10 AWG, - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 7
to the off position and, if available, install an approved safety locking device to the circuit following steps: 1 Strip the insulation from the ends of the DC power wires, exposing approximately 4.5 optional) Green 10 AWG 2 -48 VDC Black 10 AWG 3 48 VDC return Red 10 AWG Cabling Instructions - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 8
end of the green/yellow wire, exposing approximately 4.5 mm (0.175 inches) of copper wire. 2 Using a hand-crimping tool, crimp the ring-tongue terminal to the green/yellow wire. 3 Connect the safety ground to the grounding post 4 #8-32 nut 2 grounding post 3 locking washer Connecting the -48 - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 9
Dell™ PowerEdge™ 2950 系统 有关 -48 VDC www.dell.com | support.dell.com - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 10
2006-2007 Dell Inc Dell Inc Dell、 DELL 徽标和 PowerEdge 是 Dell Inc Dell Inc 2007 年 3 月 P/N GJ891 修订版 A04 - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 11
48 VDC 48 VDC ANSI NFPA) 70 AWG) 10 90ºC 30 A 48 V (1 48 VDC 48 VDC SELV 48 VDC 输入要求 -(48-60) VDC 20 A 有关 -48 VDC 9 - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 12
套件内容 • Tyco 556879-3 1 Tyco 556880-2 3 AMP 2-320568-2 1 8-32 螺帽 (1 个) 所需工具 10 AWG Alpha 3080 65/30 绞合) • 一根 UL 1015 10 AWG、 2 m 48 VDC UL 1015 10 AWG、 2 m 48 VDC UL 1015 10 AWG、 2 m UL 1015 10 AWG、 2 m AMP 90871-1 1 4.5 mm (0.175 2 3 48 VDC 1 1-1 和 表 1-1 1-3 4 将黑色 -48 - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 13
图 1-3. Tyco 连接器 556879-3 1 2 3 表 1-2 插针 1 2 3 说明 48 VDC 48 VDC 48 VDC 反向 10 AWG 黑色 10 AWG 红色 10 AWG 1 4.5 mm (0.175 2 3 8-32 1-2)。 有关 -48 VDC 11 - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 14
图 1-4 1 2 3 4 1 4 #8-32 螺帽 2 接地杆 3 连接 -48 VDC 要连接 -48 VDC 48 VDC 12 有关 -48 VDC - Dell PowerEdge 2950 | Cabling Instructions for the -48 VDC Power Supply - Page 15
Printed in the U.S.A
www.dell.com | support.dell.com
Dell™ PowerEdge™ 2950 Systems
Cabling Instructions for the
–48 VDC Power Supply
Dell™ PowerEdge™ 2950
系统
有关
-48 VDC
电源设备的
布线说明