Dell PowerVault MD3200 CLI Guide - Page 107

To use the raidLevel parameter to set a RAID level of 5, enter: raidLevel=5 • When you specify physical disk locations by using enclosure ID values and slot ID values, separate the ID values with a comma. If you enter more than one set of ID values, separate each set of values by a space. Put parentheses around the set of values. For example: (0,0 0,1 0,2 0,3 1,0 1,1 1,2 1,3) • Italicized terms in the command indicate a value or information that you need to provide. For example, when you encounter the italicized term: numberOfPhysicalDisks Replace the italicized term with a value for the number of physical disks that you want to include with the command. • You can use any combination of alphanumeric characters, hyphens, and underscores for the names of the following components: - Storage arrays - Host groups - Hosts - Disk groups - Virtual disks - Host bus adapter (HBA) host ports Names can have a maximum of 30 characters. If the label contains multiple words, underscores, or hyphens, you must put quotation marks around the name. In some usages you must also put brackets around the name. The description of each parameter tells you if you must put quotation marks or brackets around a parameter value. The character string cannot contain a new line. You must use unique names or the RAID controller module firmware returns an error. NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation. Script Commands 107