Dell PowerVault MD3200 CLI Guide - Page 133
Auto Con Command on owner
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Parameter capacity owner cacheReadPrefetch segmentSize Description The size of the virtual disk that you are adding to the storage array. Size is defined in units of bytes, KB, MB, GB, or TB. NOTE: A space must be added between the last digit and the size (bytes, KB, MB, or GB) for values greater than 9. If you do not specify a capacity, all the available physical disk capacity in the disk group is used. If you do not specify the capacity unit, bytes is used as the default unit. The RAID controller module that owns the virtual disk. Valid RAID controller module identifiers are 0 or 1, where, 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. If you do not specify an owner, the RAID controller module firmware determines the owner. NOTE: The owner parameter defines which RAID controller module owns the virtual disk. The setting to turn on or turn off cache read prefetch. To turn off cache read prefetch, set this parameter to FALSE. To turn on cache read prefetch, set this parameter to TRUE. Amount of data (in KB) that the RAID controller module writes on a single physical disk in a virtual disk before writing data on the next physical disk. Valid values are 8, 16, 32, 64, 128, 256, or 512. For information about the segmentSize parameter, see "Using the Auto Configure Command" on page 53. Script Commands 133