Dell PowerVault MD3200 CLI Guide - Page 155
Diagnose RAID Controller Module, virtualDisk, removeDiskGroup
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Parameters Parameter allVirtualDisks virtualDisk or virtualDisks removeDiskGroup Description Deletes all virtual disks in a storage array. NOTE: Using the allVirtualDisks parameter deletes virtual disks until all are removed or until an error is encountered. If an error is encountered, this command does not attempt to delete the remaining virtual disks. Name of the virtual disk to delete. You can enter more than one virtual disk name. You must put brackets ([ ]) around the virtual disk name. If the virtual disk name has special characters, you must also put quotation marks (" ") around the virtual disk name. Deleting the last virtual disk in a disk group does not delete the disk group. You can have a standalone disk group (minus any virtual disks). To remove the standalone disk group, set this parameter to TRUE. To keep standalone disk groups intact, set this parameter to FALSE. Diagnose RAID Controller Module This command runs diagnostic tests on the RAID controller module. The testID parameter takes the following options, which you can use to verify that a RAID controller module is functioning correctly: • 1 - Reads the test • 2 - Performs a data loop-back test • 3 - Writes the test The diagnostic tests consist of loop-back tests in which data is written to physical disks and read from the physical disks. Script Commands 155