Dell PowerVault MD3200 CLI Guide - Page 177
Reset Storage Array Battery Install Date, Parameter, Additional Information, Syntax
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
Parameter Parameter controller Description RAID controller module to reset. Valid RAID controller module identifiers are 0 or 1, where, 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. You must put brackets ([ ]) around the RAID controller module identifier. If you do not specify an owner, the RAID controller module firmware returns a syntax error. Additional Information The RAID controller module that receives the reset RAID controller module command resets the RAID controller module specified. For example, if the reset RAID controller module command is sent to RAID controller module 0 to request a reset of RAID controller module 0, then RAID controller module 0 reboots itself by doing a soft reboot. If the reset RAID controller module command is sent to RAID controller module 0 to request a reset of RAID controller module 1, then RAID controller module 0 holds RAID controller module 1 in reset and then releases RAID controller module 1 from reset, which is a hard reboot. A soft reboot in some products only resets the IOC chip. A hard reboot resets both the IOC chip and the expander chips in the RAID controller module. Reset Storage Array Battery Install Date This command resets the age of the batteries in a storage array to zero days. You can reset the batteries for an entire storage array or just the battery for a specific RAID controller module or in a specific battery pack. Syntax reset storageArray batteryInstallDate controller= (0 | 1) Script Commands 177