Dell PowerVault MD3200 CLI Guide - Page 178
Reset Storage Array iSCSI Baseline, Parameters, Syntax, Example
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Parameters Parameter controller Description Specifies the RAID controller module that contains the battery for which to reset the age. Valid RAID controller module identifiers are 0 or 1, where, 0 is the RAID controller module on the left, and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. Use the controller parameter only for RAID controller modules with batteries. NOTE: If you do not specify a RAID controller module, the age is reset for the storage array battery or both RAID controller module batteries. If you specify a RAID controller module, then the age for only that RAID controller module battery is reset. Reset Storage Array iSCSI Baseline This command resets the iSCSI baseline for the storage array to 0. Syntax reset storageArray iscsiStatsBaseline Parameters None. NOTE: This command resets the baseline to 0 for both RAID controller modules in the storage array. The purpose of resetting both of the RAID controller module baselines is to help ensure that the counts are synchronized between the RAID controller modules. If one RAID controller module resets but the second RAID controller module does not reset, the host is informed that the RAID controller modules are out of synchronization. The host is informed by the time stamps that are reported with the statistics. Example -c "reset storageArray iscsiStatsBaseline;" 178 Script Commands