Dell PowerVault MD3200 CLI Guide - Page 19

Table 1-2. Command Line Parameters (continued) Parameter -c Definition Use to indicate that you are entering one or more script commands to run on the specified storage array. Terminate each command by using a semicolon (;). -d -e -F (uppercase) -f (lowercase) You cannot place more than one -c parameter on the same command line. You can include more than one script command after the -c parameter. Use to display the contents of the script configuration file. Use to disable syntax checking when executing the current CLI command. Use to specify the e-mail address from which all alerts will be sent. Use to specify a file name containing script commands intended to run on the specified storage array. This parameter is similar to the -c parameter in that both are intended for running script commands. The -c parameter allows you to execute individual script commands. The -f parameter allows you to execute script commands contained in a file. NOTE: By default, any errors encountered when running the script commands in a file are ignored, and the file continues to run. To override this behavior, use the set session errorAction=stop command in the script file. About the Command Line Interface 19