Dell PowerVault MD3200 CLI Guide - Page 21
host-name-or-IP-address, set session password
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Table 1-2. Command Line Parameters (continued) Parameter -n Definition Use to specify the name of the storage array on which to run the script commands. This name is optional when you use host-name-or-IP-address; however, if you are using the in-band method for managing the storage array, you must use the -n parameter if more than one storage array is connected to the host at the specified address. The storage array name is required when host-name-or-IP-address is not used; however, the name of the storage array configured for use in the MD Storage Manager GUI (that is, listed in the configuration file) must not be a duplicate name of any other configured storage array. -o Use with the -c or -f parameter to specify a file name for all output text that is a result of running the script commands. -p Use to specify the password for the storage array on which to run commands. A password is not necessary under the following conditions: • A password has not been set on the storage array. • The password is specified in a script file that is running. • The storage array password is specified by using the -c parameter and the set session password=password command. About the Command Line Interface 21