Dell PowerVault MD3200 CLI Guide - Page 215
Set Storage Array Redundancy Mode
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Parameters Parameter Description daysToNextLearnCycle Valid values are 0 through 7, where, 0 is immediately and 7 is in seven days. The daysToNextLearnCycle parameter takes place up to seven days after the next scheduled learn cycle. day Valid values for the day parameter include the days of the week. Setting the day causes the next learn cycle to be scheduled on the specified day, after the currently scheduled learn cycle. time The time in 24-hour format; for example 8:00 a.m. is entered as 08:00. Nine o'clock p.m. is entered as 21:00, and 9:30 p.m. is entered as 21:30. NOTE: You can set the learn cycle to occur only once during a seven-day period. The time parameter selects a specific time that you want to run the learn cycle. If a value is not entered, the command uses a default value of 00:00 (midnight). If the day and time specified are in the past, the next learn cycle takes place on the next possible day specified. Set Storage Array Redundancy Mode This command sets the redundancy mode of the storage array to either simplex or duplex. Syntax set storageArray redundancyMode=(simplex | duplex) Parameter Parameter redundancyMode Description Use simplex mode when you have a single RAID controller module. Use duplex mode when you have two RAID controller modules Script Commands 215