Dell PowerVault MD3200 CLI Guide - Page 223
Set Virtual Disk Copy, This command defines the properties for a virtual disk copy pair.
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
Set Virtual Disk Copy This command defines the properties for a virtual disk copy pair. Syntax set virtualDiskCopy target [targetName] [source [sourceName]] copyPriority=(highest | high | medium | low | lowest) targetReadOnlyEnabled=(TRUE | FALSE) Parameters Parameter Description target Specifies the name of the target virtual disk for which to define properties. You must put brackets ([ ]) around the target virtual disk name. If the target virtual disk name has special characters, you must also put quotation marks (" ") around the target virtual disk name. source Specifies the name of the source virtual disk for which to define properties. You must put brackets ([ ]) around the source virtual disk name. If the source virtual disk name has special characters, you must also put quotation marks (" ") around the source virtual disk name. copyPriority Specifies the priority that the virtual disk copy has relative to host I/O activity. Valid entries are highest, high, medium, low, or lowest. targetReadOnlyEnabled Specifies whether the target virtual disk is write enabled or read only. To be able to write to the target virtual disk, set to FALSE. To prevent writing to the target virtual disk, set to TRUE. NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to use all of the parameters. Script Commands 223