Dell PowerVault MD3200 CLI Guide - Page 47

The following commands also return information about a storage array: • show storageArray autoConfigure ("Show Storage Array Auto Configure" on page 235) • show controller NVSRAM ("Show RAID Controller Module NVSRAM" on page 232) • show storageArray unreadableSectors ("Show Storage Array Unreadable Sectors" on page 239) • show virtualDiskCopy sourceCandidates ("Show Virtual Disk Copy Source Candidates" on page 243) • show virtualDiskCopy targetCandidates ("Show Virtual Disk Copy Target Candidates" on page 244) • show virtualDisk performanceStat ("Show Disk Group Import Dependencies" on page 226) For descriptions of the show commands, including examples of the information returned by each command, see "Script Commands" on page 105. Other commands can help you learn about your storage array. To see a list of the commands, see "Commands Listed by Function" on page 108. These commands are organized by the storage array activities that the commands support. (Examples include virtual disk commands, host commands, enclosure commands, and others.) Saving a Configuration to a File CAUTION: When you write information to a file, the script engine does not check to determine if the file name already exists. If you choose the name of a file that already exists, the script engine writes over the information in the file without warning. After you have created a new configuration or if you want to copy an existing configuration for use on other storage arrays, you can save the configuration to a file. To save the configuration, use the save storageArray configuration command. Saving the configuration creates a script file that you can run on the command line. The following syntax is the general form of the command: Configuring a Storage Array 47