Dell PowerVault NX3500 Administrator's Guide - Page 47
NAS Controller Discovery, Controller MAC Addresses, Primary Network Configuration
View all Dell PowerVault NX3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
NOTE: Use MTU 9000 only if your switch supports jumbo frames and it is enabled. 6 The NAS Controller Discovery window is displayed. 7 Type in the Controller MAC addresses. Controller MAC Addresses: These are used to establish communication with the PowerVault NX3500 controllers and perform initial configuration. This can be found on the System Identification slide out tab located underneath the front bezel of the controller. The back of the tab lists the "Embedded NIC 1 MAC address". NOTE: The slide out tab has two MAC addresses. Ensure that you enter the embedded NIC Address and not the iDRAC address. 8 Enter the name used to identify the NAS cluster within the web administration interface. The cluster name should be only alphanumeric characters with no spaces or special characters other than dashes. The Primary Network Configuration window is displayed. Setting Up Your PowerVault NX3500 Solution 47