Dell VNXe2 Replacing a Solid State Disk Internal Disk in a Disk Processor Encl
Dell VNXe2 Manual
 |
View all Dell VNXe2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell VNXe2 manual content summary:
- Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 1
EMC® VNXe® Replacing a solid state internal disk in a disk processor enclosure 302-000-205 REV 02 July, 2015 This document describes how to replace a faulted solid state disk internal disk in a DPE (disk processor enclosure). The SSD Internal Disk is sometimes called an mSATA SSD. The SSD Internal - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 2
identify its intended location in the system. Refer to your Unisphere online help (Servicing your system > Adding or replacing faulted hardware components > Replace a faulted hardware component) for instructions on how to identify failures, order new parts and handle hardware components. NOTICE - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 3
Replacing a solid state internal disk in a disk processor enclosure Emergency procedures (without an ESD kit) In an emergency when an ESD kit is not available, use the following procedures to reduce the possibility of an electrostatic discharge by ensuring that your body and the subassembly are at - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 4
their weight in the rear of the component. Ensure that the back end of the replaceable unit is supported while installing or removing it. Dropping a replaceable unit could result in personal injury or damage to the to remove or install a replaceable unit. Take time to read the instructions carefully. - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 5
faulted mSATA SSD you must complete the tasks below in the order listed. This document provides instructions for completing each task. 1. Prepare the SP with the faulted mSATA SSD for service. 2. Remove the SP assembly. 3. Remove the faulted mSATA SSD. 4. Unpack the replacement mSATA SSD. 5. Install - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 6
amber and blue before continuing to the next task. The storage processor fault LED will flash alternating amber and blue while the SP remains in Service mode and is receiving active power (Figure 1 on page 6). Figure 1 SP fault LED HDMI Removing an SP assembly Before you begin Locate the faulted SP - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 7
assembly is released from the enclosure. 4. Use the latches to slide the SP assembly about half-way out of the enclosure. 5. Use both hands to support the SP assembly and pull it fully out of the enclosure. 6. Place the SP assembly on a clean, flat static-free work surface. Figure 3 Removing an - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 8
Removing an mSATA SSD The mSATA SSD is located under the plastic cover on the bottom of the SP assembly. Procedure 1. Attach an ESD wristband to your wrist and to the SP assembly. 2. Expose the mSATA SSD (Figure 4 on page 8): a. Turn the SP assembly over so that its bottom side faces up. b. Push the - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 9
Replacing a solid state internal disk in a disk processor enclosure Figure 5 Removing an mSATA SSD 1 2 3 CL5265 Installing the mSATA SSD Procedure 1. Insert the mSATA SSD into the SP assembly (Figure 6 on page 9): a. Holding the mSATA SSD at about a 45º angle, align the SSD with the connector. - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 10
Figure 7 Closing the plastic cover CL5274 3. Turn the SP assembly so its top side faces up. Installing an SP assembly Refer to Figure 8 on page 10 while performing the procedure that follows. Procedure 1. Pull out the latches on each side of the SP assembly and make sure they stay in the open - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 11
for the system to complete its reboot to return to normal mode. 5. Either refresh your browser or follow the on-screen instructions to bring the software out of service mode and restore full-function Unisphere. Verifying the operation of a part Verify that the new part is recognized by your system - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 12
parts, from Unisphere, click Support > Need more Help? > Customer Replaceable Parts > Return a Customer Replaceable Part to enter the EMC Online Support website. If your screen does not show the Return a customer replaceable part option, contact your service provider for instructions on what to do - Dell VNXe2 | Replacing a Solid State Disk Internal Disk in a Disk Processor Encl - Page 13
used herein are the property of their respective owners. For the most up-to-date regulatory document for your product line, go to EMC Online Support (https://support.emc.com). Returning a faulted part 13
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
 |
 |
EMC
®
VNXe
®
Replacing a solid state internal disk in a disk
processor enclosure
302-000-205
REV 02
July, 2015
This document describes how to replace a faulted solid state disk internal disk in a DPE
(disk processor enclosure).
The SSD Internal Disk is sometimes called an mSATA SSD. The SSD Internal Disk is located
under the plastic cover on the bottom of the SP assembly. You remove an SP assembly
from the rear of the enclosure.
Topics include:
l
Before you start
..........................................................................................................
2
l
Handling replaceable units
........................................................................................
2
l
Replacing the faulted hardware component
...............................................................
5
l
Returning a faulted part
...........................................................................................
11