Denon AVR 2807 Owners Manual - English - Page 59
Setting the Volume Control, Setting the Trigger Out
UPC - 081757507059
View all Denon AVR 2807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Advanced Setup - Part 1 Setting the Volume Control This sets the volume level of output. 1 2 1 Press D H to select "Volume Control", then press ENTER. Advanced Setup - Part 1 4 Press D H to select the input source, then press F G to set. ON, OFF: When that input source is selected, the power supplied from the trigger out jack turns on (or off). 2 Press D H to select the item, then press F G to set. Vol. Limit: Set the volume's upper limit. • OFF: If you do not want to set a volume limit, select "OFF". In this case, the volume can be set to the AVR-2807's maximum volume (output) level of +18 dB, which is extremely loud. • -20 dB, -10 dB, 0 dB: The volume cannot be increased above the selected levels. P. On Lev.: Set the volume level when the power is turned on. You can adjust the MAIN ZONE volume level within the range of -80 to +18 dB (and ZONE2 volume level within the range of -70 to +18 dB). • LAST The volume set when the AVR-2807 was last used is stored in the memory and set when the power is turned on. • - - - (Mute) The volume is always muted when the power is turned on. Mute Lev.: Set the level of volume attenuation in the mute mode. • FULL The volume is fully muted. • -20 dB, -40 dB The volume is lowered 20 dB (or 40 dB) from the current level. 3 Press ENTER. • When the power amplifier is assigned to either of the ZONE2 channels at "Power Amp Assign", "-VAR-" (only variable) is displayed and the fixed level cannot be set. 5 When "MAIN" was selected at step 3: Press D H to select the surround mode, then press F G to set. ON: If "ON" is selected when an input source set to "ON" is selected, the power supplied from the trigger out jack turns on. OFF: If "OFF" is selected when an input source set to "ON" is selected, the power supplied from the trigger out jack turns off. 6 Press ENTER. Setting the Trigger Out 1 Use the DC12V output of the AVR-2807's 2 trigger out jacks in association with the various input sources and surround modes. 2 3 If "ZONE = MAIN" is selected, settings can be made for the individual surround modes. 1 Press D H to select "Trigger Out", then press ENTER. 2 Press D H to select the trigger out jacks, then press ENTER. 4 5 3 Press F G to select "MAIN" or "ZONE2". The power supplied from the trigger out jack turns on and off when the power for the set zone is turned on and off. 55