Denon AVR1910 Owners Manual - English - Page 27
Check Audyssey Auto Setup, Measurement Results Parameter Check
UPC - 083795000899
View all Denon AVR1910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup) Error Messages If the Audyssey Auto Setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the Audyssey Auto Setup procedure over again. NOTE Be sure to turn the power off before checking the speaker connections. Error messages (examples) Caution MultEQ FMicrophone:None or Speaker :None Cause • Included setup microphone is not connected. • Not all speakers could be detected. • The front L speaker was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Check the speaker connections. Check Audyssey Auto Setup Measurement Results (Parameter Check) This is displayed after the Audyssey Auto Setup procedure is completed. 1 Press ui to select "Parameter Check", then press . "Parameter Check" is displayed on the on-screen display. 3-2.Parameter Check Speaker Config.Check Distance Chenck Channel Level Check Crossover Freq.Check EQ Check Restore [ENT]:Select [RTN]:Back Retry Cancel Front [ENT]:Retry Caution MultEQ FAmbient noise is too high or Level is too low. Retry Cancel • Too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Try again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. [ENT]:Retry Caution MultEQ Front R :None Retry Cancel Skip [ ]:Up/Down [ ]:CH Caution MultEQ Front L :Phase Retry Cancel Skip [ ]:Up/Down [ ]:CH • Displayed speaker could not be detected. · The front R speaker were not properly detected. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the polarities reversed. • Check the connections of the displayed speaker. • Check the polarities of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, press ui to select "Skip", then press . 2 Use ui to select the item you want to check, then press . Speaker Config. Check : Check the speaker configuration Distance Check : Check the distance Channel Level Check : Check the channel level Crossover Freq. Check : Check the crossover frequency EQ Check : Check the equalizer 3 Use o p to switch the display between the different speakers. 4 Press . The confirmation screen reappears. Repeat steps 2 and 3. Even if the settings are changed after the Audyssey Auto Setup procedure, the Audyssey Auto Setup settings can be restored by selecting "Restore" then pressing . n To perform the Audyssey Auto Setup procedure again Press ui to select "Retry", then press . n To cancel Audyssey Auto Setup Use ui to select "Cancel", then select "Yes" using o p. 24