Denon AVR1910 Owners Manual - English - Page 54
Playing 2-Channel Sound in ZONE2 multizone function - avr 1910 hdmi
UPC - 083795000899
View all Denon AVR1910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH Playing 2-Channel Sound in ZONE2 (multizone function) 2-channel sound can be played in rooms other than the MAIN ZONE where multichannel sound is played. There are two methods to do this, as described below. Choose one of the methods. q ZONE2 playback by speaker output w ZONE2 playback by audio output (PRE OUT) (using an external amplifier)) q ZONE2 playback by speaker output With the Amp Assign function, Zone 2 audio signals are output from the AVR-1910's SURR BACK/AMP ASSIGN terminals. w ZONE2 playback by audio output The audio signals connected to the AVR-1910's ZONE2 output terminals (ZONE2 OUT) are output to the ZONE2's amplifier and played with that amplifier. Connection (ZONE2) MAIN ZONE Playback The operation is the same for "q ZONE2 playback by speaker output" and "w ZONE2 playback by audio output". 1 Set the remote control unit's "device selector switches" as shown on right. 2 Turn on the AVR-1910's power. (vpage 17 "Turning the Power On") Rear Preparations Connecting and setting the speakers n Connecting the speakers AVR-1910 3 Press to turn on the ZONE2 power. When the power turns on, the " " indicator lights on the RL display. b The power can be turned on by pressing the one of while in the standby mode. (L) (R) w qw q ZONE2 RL "69 */ 4 Use the input source selector to choose the input source. The selected input source is shown on the display. NOTE When "SOURCE" is selected for the input source, the sound being played in the MAIN ZONE is played. No sound is output if a digital audio input source is being played in the MAIN ZONE. n Necessary settings • Set the AMP ASSIGN mode to "ZONE2". "AMP Assign" (vpage 25) • Perform the settings at "ZONE2 Setup". "Making the ZONE2 settings" (vpage 30) Adjusting the volume (for "q ZONE2 playback by speaker output") Use to adjust the volume. • Adjust the volume on the connected amplifier. • Also be sure to read the operating instructions of the connected devices. NOTE • We recommend using high quality pin-plug cables for audio connections in order to prevent noise. • It is not possible to play the digital audio signals input from the HDMI, COAXIAL or OPTICAL terminals in ZONE2. Play using analog connections (in stereo). GVariable rangeH - - - -80dB(1) ~ -40dB(41) ~ +18dB(99) b The volume can be adjusted up to the level set at "Vol. Limit" (vpage 30). b The volume display is the display set at "Volume Display" (vpage 30). For "w ZONE2 playback by audio output", adjust the volume on the connected amplifier. 51