Denon AVR1910 Owners Manual - English - Page 67

Restoring all the settings to as they were at the time of purchase (Resetting the Microprocessor) Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. 1 Turn off the power using on the main unit. 2 Press while simultaneously pressing and on the main unit. 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. ENGLISH Specifications n Audio section • Power amplifier Rated output: Front (A, B): 90 W+90 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.) 125 W+125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Center: 90 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.) 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Surround: 90 W+90 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.) 125 W+125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Surround Back: 90 W+90 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.08 % T.H.D.) 125 W+125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Output connectors: Front: A or B 6～16 Ω/ohms A + B 12～16 Ω/ohms Center, Surround, Surround Back / Amp Assign: 6～16 Ω/ohms • Analog Input sensitivity / Input impedance: 200 mV / 47 kΩ/kohms Frequency response: 10 Hz ~ 100 kHz - +1, -3 dB (DIRECT mode) S/N: 100 dB (IHF-A weighted, DIRECT mode) n Video section • Standard video connectors Input / output level and impedance: 1 Vp-p, 75 Ω/ohms Frequency response: 5 Hz ~ 10 MHz - +1, -3 dB • Color component video connector Input / output level and impedance: Y (brightness) signal - 1 Vp-p, 75 Ω/ohms PB / CB signal - 0.7 Vp-p, 75 Ω/ohms PR / CR signal - 0.7 Vp-p, 75 Ω/ohms Frequency response: 5 Hz ~ 60 MHz - +0, -3 dB n Tuner section [FM] [AM] (note: µV at 75 Ω/ohms, 0 dBf = 1 x 10-15 W) Receiving Range: 87.5 MHz ~ 107.9 MHz 520 kHz ~ 1710 kHz Usable Sensitivity: 1.2 µV (12.8 dBf) 18 µV 50 dB Quieting Sensitivity: MONO 2.8 µV (20.2 dBf) STEREO 48.7 µV (45.0 dBf) S/N (IHF-A): MONO 70 dB STEREO 67 dB Total harmonic Distortion (at 1 kHz): MONO 0.7 % STEREO 1.0 % n General Power supply: AC 120 V, 60 Hz Power consumption: 5.5 A 0.3 W (Standby) Maximum external dimensions: 434 (W) x 171 (H) x 377 (D) mm (17-3/32" x 6-47/64" x 14-27/32") Weight: 10.7 kg (25 lbs 5.7 oz) n Remote control unit (RC-1117) Batteries: R6/AA Type (two batteries) Maximum external dimensions: 52 (W) x 243 (H) x 21 (D) mm (2-3/64" x 9-9/16" x 53/64") Weight: 184 g (Approx 6.5 oz) (including batteries) z For purposes of improvement, specifications and design are subject to change without notice. 64 Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications