Denon AVR5700 Owners Manual - Page 34

System call function • The included remote control unit is equipped with a system call function for transmitting multiple remote control signals when a single button is pressed (this is often referred to as a "macro" function). This function can be used to turn on the amplifier's power, select the input source, turn on the monitor TV's power, turn on a source component's power and start playback, etc., all at the touch of a button. (1) System call buttons The buttons that can be used for the system call function are shown on the table below. A series of up to 10 operations can be performed with the POWER ON and OFF buttons, and a series of up to 5 operations can be performed with other buttons. System call signals are already preset at the buttons indicated in the shaded section. System call signals can also be stored at any button on the remote control unit, including the buttons in this section. (See page 35.) Button No. transmissions POWER OFF (key 3) 10 POWER OFF (key 4) 10 Stored operation 1 DVD (key 5) 5 Receiver power on VDP (key 6) 5 Receiver power on TV/DBS (key 9) 5 Receiver power on V.AUX (key 10) 5 Receiver power on VCR-1 (key 13) 5 Receiver power on CD (key 14) 5 Receiver power on Stored operation 2 Stored operation 3 Stored operation 4 Stored operation 5 DVD player (DVD) power on LD player (VDP) power on TV power on TV power on Video (VCR) power on Receiver input source switched to CD Receiver input source switched to DVD Receiver input source switched to VDP Receiver input source switched to TV/DBS Receiver input source switched to V.AUX Receiver input source switched to VCR-1 TV power on TV power on TV power on DVD player (DVD) playback LD player (VDP) playback Video (VCR) playback Stored operation 6 Stored Stored Stored Stored operation 7 operation 8 operation 9 operation 10 The system call signals for the POWER OFF and POWER ON buttons are transmitted from the remote control unit approximately once every second. The signals for the other buttons (DVD, VDP, TV/DBS, V.AUX, VCR-1 and CD) are transmitted approximately once every 1.5 seconds. (2) Using the system call function 1 Press the system call button. • The LEARNED/TX LED flashes for 5 seconds. CALL 2 Press the button at which the desired system call signals are stored while the LEARNED/TX LED is flashing. • The preset signals or the signals you have stored at that button are transmitted in succession. 2 START SYSTEM CALL SET CALL DVD VDP 1 2 TV/DBS 4 V.AUX 5 VCR-1 CD 7 8 VCR-2 +10 0 RC-853 LEARNED/TX POWER OFF ON / SOURCE TUNER 3 SHIFT PHONO 6 MD / TAPE-1 9 CHANNEL TAPE-2 MON TV/VCR A / B 1 VOLUME DISC SKIP+ DOLBY / DTS HOME THX CINEMA SURROUND DIRECT DSP SIMULATION 5CH STEREO INPUT MODE ANALOG STEREO EXT.IN MASTER VOL. AUDIO DECK MD CD LOCK MUTING AVR/AVC VIDEO TUNING DVD TV VDP VCR SYSTEM SETUP SURROUND PARAMETER BAND MODE TITLE MENU/GUIDE CH SELECT ENTER 34