Denon DRA 395 Owners Manual - Page 16

ENGLISH 2 Multi-source and multi-zone playback MULTI ROOM MUSIC ENTERTAINMENT SYSTEM • When the outputs of the MULTI SOURCE AUDIO/VIDEO OUT terminals are wired and connected to power amplifiers or TV displays installed in other rooms, different sources can be played in rooms other than the main room in which this unit and the playback devices are installed. (Refer to ZONE 2, 3 ROOM on the diagram.) • When the output of the SPEAKER SYSTEM-B terminals is wired and connected to speakers in a sub room, the same source can be played in both the main room and sub room. Set the this unit's SPEAKER A/B selector according to the room in which the source is to be played. (Refer to SUB ROOM on the diagram.) • When a separately sold room-to-room remote control unit (DENON RC-616 or 617) is wired and connected between the main room, the ZONE 2/3 ROOM and the sub room, the remote-controllable devices in the main room can be controlled from the ZONE 2/3 ROOM and the sub room using the remote control unit. MULTI ROOM MUSIC ENTERTAINMENT SYSTEM ZONE 2 ROOM MAIN ROOM ZONE 3 ROOM AMPLIFIRE TV RC-894 (or PROGRAMABLE REMOTE CONTROL UNIT RC-8000) RC-617 • Accessories • SYSTEM REMOTE CONTROL UNIT RC-894 • Sold Separately • IR RETRANSMITTER RC-616 • IR SENSOR RC-617 • PROGRAMABLE REMOTE CONTROL UNIT RC-770 RC-616 B DRA-395 SPEAKER SYSTEM -B SYSTEM REMOTE CONTROL UNIT RC-894 RC-617 TV AMPLIFIRE RC-894 (or PROGRAMABLE REMOTE CONTROL UNIT RC-8000) ROOM-TO-ROOM REMOTE CONTROL SYSTEM (separately sold) control line MULTI SOURCE AUDIO signal cable MULTI SOURCE VIDEO signal cable (75 º / ohms) SPEAKER cable Refer to CONNECTIONS on pages 6 and 7. SUB ROOM RC-617 RC-894 (or PROGRAMABLE REMOTE CONTROL UNIT RC-8000) With ZONE 2 ROOM and ZONE 3 ROOM multi-source playback, this unit's MULTI SOURCE output can be controlled with the included remote control unit. The ZONE 2/3 mode cannot be selected from the remote control unit when the main unit is set to the REC OUT mode. With ZONE 2/3 ROOM playback, the this unit and DENON CD players or tape decks etc, can be controlled using the included remote control unit. To control playback devices other than the ones above, either use that device's remote control unit or preset a separately sold programmable remote control unit (DENON RC-8000, etc.). When the ZONE 2, ZONE 3 or rec out mode is set, the signal of the source selected in any mode is output for all output terminals (ZONE 2, ZONE 3 or rec output). NOTE: • Use a 75 Ω /ohms coaxial pin-plug cord for video signals to connect and wire the MULTI SOURCE VIDEO output. For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming or noise. • For instructions on installation and operation of separately sold devices, refer to the devices' operating instructions. 16