Dewalt DC9000 Instruction Manual
Dewalt DC9000 Manual
View all Dewalt DC9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dewalt DC9000 manual content summary:
- Dewalt DC9000 | Instruction Manual
- Page 1
Pack Instructions 1. Unplug the charger 2. Place Charger Test Pack in Charger 3. Plug in the charger 4. Observe 3 LEDs in the Test Pack 5. Cycle Power to charger (unplug and re- plug) *Note: Use this Charger Test Pack Procedure to confirm that a charger is OK. Step #5 is critical...the charger will
PASS
FAIL
1.
Any LEDs Red after 40 sec
1.
All 3 LEDs Green after 40 sec
Page 8
1.
Unplug the charger
2.
Place Charger Test Pack in Charger
3.
Plug in the charger
4.
Observe 3 LEDs in the Test Pack
5.
Cycle Power to charger (unplug and re-
plug)
Charger Test Pack Instructions
*Note: Use this Charger Test Pack Procedure to confirm that a
charger is OK. Step #5 is critical…the charger will not function
normally after the test until the main power is cycled.