Home » Edimax Manuals » Wireless » Edimax EW-7622UMn » Manual Viewer

Edimax EW-7622UMn Manual

View all Edimax EW-7622UMn manuals

Add to My Manuals
Save this manual to your list of manuals

Edimax EW-7622UMn manual content summary:

Edimax EW-7622UMn | Manual - Page 1
Edimax EW-7622UMn | Manual - Page 2
, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, this company reserves
Edimax EW-7622UMn | Manual - Page 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
Edimax EW-7622UMn | Manual - Page 4
Exposure Statement This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C. The equipment version marketed in US is restricted
Edimax EW-7622UMn | Manual - Page 5
R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE) The R&TTE Directive
Edimax EW-7622UMn | Manual - Page 6
and the setup screen may appear slightly different from those shown in this QIG. For more detailed information about this product, please refer to the User Manual on the CD-ROM. The software and specifications are subject to change without notice. Please visit our web site www.edimax.com for
Edimax EW-7622UMn | Manual - Page 7
Network ...17 3.3 General ...18 3.4 Profile...20 3.4.1 Configure the Profile 21 3.5 Status ...25 3.6 Statistics ...26 3.7 Wi-Fi Protect Setup (WPS 27 3.8 Software AP ...30 3.8.1 AP Properties Setting 31 3.8.2 AP Advanced ...32 3.8.3 AP Statistics ...33 3.8.4 SoftAP ...34 4 TROUBLESHOOTING 35
Edimax EW-7622UMn | Manual - Page 8
Scientific Medical Band)  Data Rate: 11b: 1/2/5.5/11Mbps 11g: 6/9/12/24/36/48/54Mbps 11n (20MHz): MCS0-15 (up to 150Mbps) 11n (40MHz): MCS0-15 (up to 300Mbps)  Security: 64/128-bit WEP Data Encryption, WPA, WPA2  Antenna: Chip Antenna  Drivers: Windows 2000/XP/Vista/7  LEDs: Link/Activity 1
Edimax EW-7622UMn | Manual - Page 9
Before you begin the installation, please check the items of your package. The package should include the following items:  One USB Adapter  One CD (Driver/Utility/User‟s Manual)  One Quick Guide  USB cable If any of the above items is missing, contact your supplier as soon as possible. 2
Edimax EW-7622UMn | Manual - Page 10
operated under Windows XP. (Procedures are similar for Windows 2000/Vista/7.) Note2: If you have installed the Wireless PC Adapter driver & utility before, please uninstall the old version first. Hardware Installation Please follow the following instructions to install your new USB wireless network
Edimax EW-7622UMn | Manual - Page 11
The following message will appear on your computer, click „Cancel‟ 4
Edimax EW-7622UMn | Manual - Page 12
Software Installation This wizard can be run in Windows 2000/XP/Vista/7. You can install the Wireless Adapter by EZMAX Setup Wizard in the CD-ROM including in the package. The wizard is an easy and quick configuration tool for internet connection with series process. When you start EZMAX Setup
Edimax EW-7622UMn | Manual - Page 13
I. Install the Driver and Utility If you prefer the traditional setup procedure. Please insert the installation CD to your CD-ROM Drive, and click " Exit " to disable EZmax Wizard. If your OS is Windows 2000/XP/Vista/7. Please execute the " Utility \ Setup.exe " program as follows. 6
Edimax EW-7622UMn | Manual - Page 14
Select Setup Language and click "OK" to proceed. 7
Edimax EW-7622UMn | Manual - Page 15
Click "Next" to go to the next step. Now you‟ll see the following message, please click „Install‟ to begin the installation. 8
Edimax EW-7622UMn | Manual - Page 16
The system starts to install the driver and utility. Click "Finish" to complete the driver and utility installation. 9
Edimax EW-7622UMn | Manual - Page 17
Access Point A. To start configuring the adapter, double click the icon in the system tray or right click the icon and select open configuration utility. B. The utility of the adapter is displayed. Click "Available Network" and double-click on the wireless access point you want to connect to
Edimax EW-7622UMn | Manual - Page 18
C. Input the security setting and click "OK" to start network connection. 11
Edimax EW-7622UMn | Manual - Page 19
Zero Configuration on Windows Vista: A. For Windows Vista user, you can use Windows Zero Configuration to connect to wireless access point. Click „Start‟ button, then click „Control Panel. Click „Network and Internet‟ in Control Panel. B. Click „Connect to a network‟ under „Network and Sharing
Edimax EW-7622UMn | Manual - Page 20
want to use if it‟s shown, then click „Connect‟. D. If it‟s an unnamed access point (i.e. the SSID of this wireless access point is hidden), you‟ll be prompted to input it‟s name, and the name must be identical to the SSID setting of the wireless access point you‟re connecting to. 13
Edimax EW-7622UMn | Manual - Page 21
or passphrase here. It must match the encryption setting on the access point. F. If you can see this image, the connection between your computer and wireless access point is successfully established. Click „Close‟ to start network connection. 14
Edimax EW-7622UMn | Manual - Page 22
is a powerful application that helps you configure the Wireless LAN Mini USB Adapter and monitor the link status and the statistics during the communication process. The Configuration Utility appears as an icon on the system tray and desktop of Windows. You can open it by double-click on the icon
Edimax EW-7622UMn | Manual - Page 23
and Access Point. If "Station" is selected, the adapter works as a wireless adapter. If "Access Point" is selected, the adapter will works as a wireless AP. View - Enable "Status Bar" and the "D" block in the utility will display the current status of the utility. About - To check the version of the
Edimax EW-7622UMn | Manual - Page 24
" in the "View" item. There are several tabs in the block for you to setup the function of E the adapter. Please refer to the description in the following sections. 3.2 Available Network When you open the Configuration Utility, the system will scan all the channels to find all the access points
Edimax EW-7622UMn | Manual - Page 25
to the network quickly. To add the selected network to a profile, click this button. 3.3 General To check the connection status of the adapter, select "General". This screen shows the information of Link Speed, Network Type, Encryption Method, SSID, Signal Strength, Link Quality and Network Address
Edimax EW-7622UMn | Manual - Page 26
32 printable ASCII characters) is the unique name identified in a WLAN. The ID prevents the unintentional merging of two co-located WLANs. It indicates the wireless signal strength. It indicates the wireless link quality. It shows the MAC, IP address and other information of the adapter. 19
Edimax EW-7622UMn | Manual - Page 27
to manage a profile. Parameter Available Profile(s) Add/ Remove/ Edit Button Duplicate Set Default Description This list shows the preferred networks for the wireless connection. You can add, remove, edit, duplicate the preferred networks or set one of the networks as the default connection. Click
Edimax EW-7622UMn | Manual - Page 28
of an points are not used. 802.11 Access Point. All communication is done via the Access Point or Router. Ad Hoc - Connect to another wireless adapter in the Wireless LAN network without through an Access Point or Router. If this item is selected, the
Edimax EW-7622UMn | Manual - Page 29
wireless networks that the adapter intends to connect. Open System - No authentication is needed among the wireless network. Shared Key - Only wireless manually enters the starting password in their access point or gateway, as well as in each wireless - Like WPA, WPA2 supports IEEE 802.1x/EAP
Edimax EW-7622UMn | Manual - Page 30
a text string with a maximum of 32 alphanumeric characters, for example: "Test". The WEP Key is based upon the Passphrase determined by you. This the utility. The keys are used to encrypt data transmitted in the wireless network. Fill the text box by following the rules below. 64-bit - Input 10-
Edimax EW-7622UMn | Manual - Page 31
and TTLS are similar and easier than TLS in that they specify a stand-alone authentication protocol be used within an encrypted tunnel. TTLS supports any protocol within its tunnel, including CHAP, MSCHAP, MSCHAPv2 and PAP. PEAP specifies that an EAP-compliant authentication protocol must be used
Edimax EW-7622UMn | Manual - Page 32
3.5 Status This screen shows the information of manufacturer, driver version, settings of the wireless network the adapter is connecting to, linking time and link status. If you don‟t ensure the status of the adapter and the network you are connecting, please go to the screen for more details. 25
Edimax EW-7622UMn | Manual - Page 33
3.6 Statistics You can get the real time information about the packet transmission and receiving status during wireless communication from the screen. If you want to recount the statistics value, please click "Reset". 26
Edimax EW-7622UMn | Manual - Page 34
wireless access point and setup data encryption by yourself. All you have to do is to go to the WPS setup page of this wireless utility. Remember it, and input the number to your wireless access point as the WPS PIN code (Please refer to the user manual of your wireless access point for instructions
Edimax EW-7622UMn | Manual - Page 35
message will appear on your computer, please select the SSID of wireless access point that you wish to connect and click „Select‟. 4. Please wait while the install procedure is running and wait for few seconds to two minutes. If a wireless access point with correct PIN code is found, you‟ll be
Edimax EW-7622UMn | Manual - Page 36
PBC) 1. Start PBC pairing procedure at access point side (please refer to the instruction given by your access point‟s manufacturer), then click „PBC‟ button in wireless configuration utility to start to establish wireless connection by WPS. Please be patient (This may require several seconds to one
Edimax EW-7622UMn | Manual - Page 37
two co-located WLANs. The default SSID of the AP is Full Computer Name + "_AP". Wireless adapters connect to the AP should set up the same SSID as the AP. Display the MAC address of the adapter. All the wireless adapters connected to the software AP will be displayed in the list. Click "Config" for
Edimax EW-7622UMn | Manual - Page 38
3.8.1 AP Properties Setting Please refer to Section 3.4.1 for the setting of the parameters for AP. Note that Ad Hoc mode is not enabled for AP. 31
Edimax EW-7622UMn | Manual - Page 39
3.8.2 AP Advanced Parameter Beacon Interval DTIM Period Preamble Set Defaults Apply Description value is 3 beacons. The preamble defines the length of the CRC block for communication among the wireless stations. There are two mode including Long and Short. High network traffic areas should use the
Edimax EW-7622UMn | Manual - Page 40
3.8.3 AP Statistics You can get the real time information about the packet transmission and receiving status during wireless communication from the screen. If you want to recount the statistics value, please click "Reset". 33
Edimax EW-7622UMn | Manual - Page 41
3.8.4 ICS If you want to connect to the internet through this SoftAP, you will need to make a bridge between our SoftAP and your internet connect. Select the internet connection in your SoftAP host machine and press the "Apply" button. 34
Edimax EW-7622UMn | Manual - Page 42
Troubleshooting This chapter provides solutions to problems usually encountered during the installation and operation of the adapter. 1. What is the IEEE 802.11g standard? 802.11g is the new IEEE standard for high-speed wireless the 802.11 Medium Access Control (MAC) in the 2.4 GHz frequency band,
Edimax EW-7622UMn | Manual - Page 43
Basic Service Set 10. Can Wireless products support printer sharing？ Wireless products perform the same function as LAN products. Therefore, Wireless products can work with Netware, Windows 2000, or other LAN operating systems to support called a chip (or chipping code). The longer the chip is, the
Edimax EW-7622UMn | Manual - Page 44
13. What is Spread Spectrum？ Spread Spectrum technology is a wideband radio frequency technique developed by the military for use in reliable, secure, mission-critical communication systems. It is designed to trade off bandwidth efficiency for reliability, integrity, and security. In other words,
Edimax EW-7622UMn | Manual - Page 45
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
Edimax EW-7622UMn | Manual - Page 46
use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland. EU Countries not intended for use None Please check the declaration of conformity on www.edimax.com 39
Edimax EW-7622UMn | Manual - Page 47
40

Match case Limit results 1 per page