Electrolux E30GC70FSS Owners Guide

Electrolux E30GC70FSS Manual

Get Electrolux E30GC70FSS PDF manuals and user guides View all Electrolux E30GC70FSS manuals
Add to My Manuals
Save this manual to your list of manuals

Electrolux E30GC70FSS manual content summary:

  • Electrolux E30GC70FSS | Owners Guide - Page 1
    Use & Care Guide Gas Cooktop 318 200 676 (0602)
  • Electrolux E30GC70FSS | Owners Guide - Page 2
    is located under the burner box. QUESTIONS? For toll-free telephone support in the U.S. and Canada: 1-877-4ELECTROLUX (1-877-435-3287) For on-line support and internet product information: www.electrolux.com ©2006 Electrolux Home Products, Inc. Post Office Box 212378, Augusta, Georgia 30917, USA
  • Electrolux E30GC70FSS | Owners Guide - Page 3
    4-6 Important Safety Instructions 4 Getting Start 7 Grounding Instructions 7 Liquefied Petroleum (Propane) Gas Conversion 7 Surface Cooking Heads 13 Porcelain Enamel Cooktop Cleaning Instructions 14 Care & Cleaning of Stainless Steel 14 Solutions to Common Problems 15 Surface Burner Do Not
  • Electrolux E30GC70FSS | Owners Guide - Page 4
    's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. - Installation and service must be performed by a qualified installer, servicer or the gas supplier. • Remove all tape and packaging before using the Cooktop. Destroy the carton and
  • Electrolux E30GC70FSS | Owners Guide - Page 5
    to shut off gas supply at the meter and disconnect the electrical power to the cooktop at the circuit breaker or fuse box in case of an emergency. • User servicing-Do not repair or replace any part of the appliance unless specifically recommended in the manuals. All other servicing should be done
  • Electrolux E30GC70FSS | Owners Guide - Page 6
    knob controls each surface burner. Always turn the knob 's instructions for part of the cooktop, use aluminum foil only to cover food during cooking. Improper installation cooktop service without breaking due to the sudden change in temperature. Check the manufacturer's recommendations for cooktop
  • Electrolux E30GC70FSS | Owners Guide - Page 7
    for use with natural gas. A kit for converting to LP gas is supplied with your cooktop. The kit is marked "FOR LP/ PROPANE GAS CONVERSION". Follow the installation instructions which are inside the envelope. The conversion must be performed by a qualified service technician in accordance with
  • Electrolux E30GC70FSS | Owners Guide - Page 8
    . Use the chart below as a guide for determining proper flame size for various a thermometer and adjust the surface control knob accordingly. If the fat is too cool *These settings are based on using medium-weight aluminum pans with lids. Settings may vary instructions under General Care & Cleaning.
  • Electrolux E30GC70FSS | Owners Guide - Page 9
    MED LO LO l ite HI l ite HI OFF OFF MED MED LO LO 36" cooktop Place burner head over each gas orifice, matching the head with the orifice size. Be careful not to damage does not light, contact a Service Center. Do not service the sealed burner yourself. Burner Cap Burner Head Electrode
  • Electrolux E30GC70FSS | Owners Guide - Page 10
    not slide the grates on the cooktop, doing so can damage the * Specialty pans such as lobster pots, griddles and pressure cookers may be used but and straight sides. • Tight fitting lids. • Weight of handle does not tilt pan. Pan is well manufacturer's instructions. Some utensils were not made to be used in
  • Electrolux E30GC70FSS | Owners Guide - Page 11
    or plastic wrappings on top of the cooktop when it is in use. These items knob to the desired flame size. The control knobs do not have to be set at a particular mark. Use the guides manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the Surface Control knob
  • Electrolux E30GC70FSS | Owners Guide - Page 12
    Knobs cooktop must be kept clean at all times for proper ignition and a complete, even flame. Clean the burner holes routinely with a small gauge wire or needle and especially after bad spillovers which could clog these holes. To remove, clean and replace sealed burner units; follow the instructions
  • Electrolux E30GC70FSS | Owners Guide - Page 13
    following instructions: To Remove and Replace the replace the Surface Burner Cap, Surface Burner Head and Surface Burner Grate. Do not remove any burner parts from the cooktop until the 1st burner parts heads. The Grates are designed to be Dishwasher safe for gas and ignition of the burner-DO
  • Electrolux E30GC70FSS | Owners Guide - Page 14
    COOKTOP CLEANING INSTRUCTIONS WARNING Do not use a cooktop cleaner on a hot cooktop. The fumes can be hazardous to your health, and can chemically damage the cooking surface. CAUTION Before cleaning the surface cooktop burned-on soil: 1. Allow cooktop surface to cool. 2. Use parts. Please refer to
  • Electrolux E30GC70FSS | Owners Guide - Page 15
    to Common Problems 15 I M P O R TA N T Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that are not the result of defective workmanship or material in your cooktop. SURFACE BURNERS DO NOT LIGHT • Surface Control knob has not
  • Electrolux E30GC70FSS | Owners Guide - Page 16
    the product. 2. Proper installation by an authorized servicer in accordance with instructions provided with the appliance and in accordance with all local plumbing, electrical and/or gas codes. 3.Proper connection to a grounded power supply of sufficient voltage, replacement of blown fuses, repair
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
Use & Care Guide
Gas Cooktop
318 200 676 (0602)