Electrolux ECFD3068AS Quick Start Guide English
Electrolux ECFD3068AS Manual
 |
View all Electrolux ECFD3068AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Electrolux ECFD3068AS manual content summary:
- Electrolux ECFD3068AS | Quick Start Guide English - Page 1
A Quick Guide to Getting Started Before you begin 1. Remove all packaging and left side cooktop grates first, then position the middle grate in place. Refer to your Use & Care Manual for detailed instructions. 4. Set your clock: • Press in the OVEN TEMP/TIMER knob • Turn the knob right or left - Electrolux ECFD3068AS | Quick Start Guide English - Page 2
area may cause damage. • Avoid using scouring pads or paper towels - they will damage the finish. Always refer to your Use & Care Manual for more tips and instructions. Visit us on ElectroluxAppliances.com and YouTube for FAQs and How to Videos. FAQs • Why does my oven make noises when I'm cooking
-
1 -
2
 |
 |
A Quick Guide to Getting Started
Rev. A
Before you begin
1.
Remove all packaging material and tape.
2.
Make sure your oven racks are in place and your
burner caps are centered on the burners.
3.
Place the right and left side cooktop grates first, then
position the middle grate in place. Refer to your Use &
Care Manual for detailed instructions.
4.
Set your clock:
•
Press in the OVEN TEMP/TIMER knob
•
Turn the knob right or left to set the correct time
•
Push the knob in to confirm the selection
5.
Prepare your range for first time use by setting Bake
at 350°F / 175°C for about 30 minutes. It's normal to
experience some smoke and noises during this time.
OPERATING THE BURNERS
1.
Place your cookware on the burner.
2.
Push in and turn the cooktop knob to the
position to ignite the burner.
3.
Check the burner to make sure it has a steady
flame.
4.
Once the burner is lit, keep the knob pressed in
for a few seconds. If the burner goes out, wait a
few moments and try again.
5.
Turn the burner knob to adjust the flame size.
NOTE
: A clicking sound will occur on all the burners
when a control knob is pushed in.
Don't cook with the knob in the
position.
BURNER KNOB POSITIONS:
position
Burner outer ring flame setting
Burner inner ring flame setting
Burner electric ignition
HIGH, MEDIUM and LOW
flame settings (for single flame and oval burners)
Gas Cooktop Basics
SETTING YOUR FLAME SIZE
The color of the flame is the key to proper burner
adjustment.
A good flame is clear,
blue and hardly visible.
Adjust or clean the
burner if flame is yellow-
orange.
Start on the highest setting and lower the setting
as needed for general cooking needs.
Use a medium or low flame when thickening
sauces or to maintain a slow boil.
USING THE INNER AND OUTER RINGS
Once the burner is lit, it will be on the highest
setting.
To lower the outer ring
setting, turn the knob to left
To turn off the outer ring,
continue to turn the knob
left .
To control only the inner
ring, push the cooktop
knob in and turn left .
Continue to turn the knob
left to decrease the inner
ring setting.
91353153
3
(Dec 2020)