Electrolux ECFG3668AS Quick Start Guide
Electrolux ECFG3668AS Manual
 |
View all Electrolux ECFG3668AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Electrolux ECFG3668AS manual content summary:
- Electrolux ECFG3668AS | Quick Start Guide - Page 1
A Quick Guide to Getting Started Before you begin 1. Remove all packaging and left side cooktop grates first, then position the middle grate in place. Refer to your Use & Care Manual for detailed instructions. 4. Set your clock: • Press in the OVEN TEMP/TIMER knob • Turn the knob right or left - Electrolux ECFG3668AS | Quick Start Guide - Page 2
control area may cause damage. • Avoid using scouring pads or paper towels - they will damage the finish. Always refer to your Use & Care Manual for more tips and instructions. Turn the OVEN MODE knob to select the oven mode or function. START flashes in the upper right corner of the display to
-
1 -
2
 |
 |
A Quick Guide to Getting Started
913531594
REV.B
(April 2022)
Before you begin
1.
Remove all packaging material and tape.
2.
Make sure your oven racks are in place and your
burner caps are centered on the burners.
3.
Place the right and left side cooktop grates first, then
position the middle grate in place. Refer to your Use &
Care Manual for detailed instructions.
4. Set your clock:
•
Press in the OVEN TEMP/TIMER knob
•
Turn the knob right or left to set the correct time
•
Push the knob in to confirm the selection
5.
Prepare your range for first time use by setting Bake
at 350°F / 175°C for about 30 minutes. It's normal to
experience some smoke and noises during this time.
OPERATING THE BURNERS
1.
Place your cookware on the burner.
2.
PUSH-IN and TURN the cooktop knob to
the
(SPARK) position to ignite the burner.
You should hear a clicking sound as the
burner ignites.
3.
Once the burner is lit, continue to PUSH-
IN and HOLD the knob in the
(SPARK)
position for 3-5 seconds.
4. Turn the burner knob to desired operating
position; HIGH, MEDIUM or LOW flame
setting.
NOTE
:
If the burner goes out in point 3, wait a
few moments and try again. Do not cook with
the knob in the
(SPARK) position.
BURNER KNOB POSITIONS:
Burner outer ring flame setting
Burner inner ring flame setting
Burner electric ignition
position
Gas Cooktop Basics
SETTING YOUR FLAME SIZE
The color of the flame is the key to proper burner
adjustment.
A good flame is clear, blue
and hardly visible. Adjust
or clean the burner if flame
is yellow-orange.
Start on the highest setting and lower the setting
as needed for general cooking needs.
Use a medium or low flame when thickening
sauces or to maintain a slow boil.
USING THE INNER AND OUTER RINGS
Once the burner is lit, it will be on the highest
setting.
To control only the inner
ring, push the cooktop knob
in and turn left.
Continue to turn the knob
left to decrease the inner
ring setting.
To lower the outer ring
setting, turn the knob to left
To turn off the outer ring,
continue to turn the knob
left.