Electrolux EIDW6105GS Complete Owner's Guide (English) - Page 21

Solutions to Common Problems 21 DISHWASHER WON'T FILL ERROR CODES • Check to see if the water supply is turned on. • Add 1/2 cup of water to the bottom of the unit and start again.off. In certain situations which are critical to machine function and safe operation. Error codes will be shown in the status window on the EIDW6305. DISHWASHER HAS AN ODOR • Soiled dishes left in dishwasher too long can create an odor. Use Rinse cycle. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly (See Dishwasher Does Not Drain Properly, page 21). REMOVING SPOTS AND FILM Hard water can cause lime deposit buildup on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons (See Glassware/Flatware Spotted or Cloudy, page 19). To remove build-up, spots and film, clean using the following instructions: 1 Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware. 2 Do not add detergent. 3 Select the NORMAL WASH cycle. Press START/CANCEL pad and close door. 4 Allow dishwasher to run until it begins the second fill. Open door and pour 2 cups of white vinegar into the bottom of dishwasher. 5 Close and latch door and allow cycle to finish. NOTE If these conditions persist, a home water softener should be considered. Er 01 Leak Detector - When water is detected under the tub. Er 02 Thermistor - When thermistor/turbidity module fails Er 03 Wash Pump - Wash pump not operating Er 04 Drying Damper - Drying damper not operating Er 05 Upper Fan - When in the dry cycle, the control board does not receive proper speed feedback from the upper fan Er 06 Lower Fan - When in the dry cycle, the control board does not receive proper speed feedback from the lower fan Er 07 Drain Valve - When in the drain mode, the control board does not receive proper position feedback from the drain valve Er 08 Tactile or touch switch - Control board has verified a switch on the user interface is bad or shorted Er 09 Communications - Communication failure between main user board and power supply Er 10 Mains Relay - Failure in the mains power relay Er 11 Drain Valve - Time out before finding a state for the drain valve Er 12 Drain Valve - The drain valve is running when it should be off Er 13 System wide - Lost control of the State Machine