Electrolux FAC124P1A Installation Instructions

Electrolux FAC124P1A Manual

Electrolux FAC124P1A manual content summary:

  • Electrolux FAC124P1A | Installation Instructions - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT Compact II Window Mounting Y_ur air conditioner is designed to install ill standard double hung windows with snap in place (Fig. G). O. Check the operation by moving the horizontal louver up and dowm and then turn the auger wheel
  • Electrolux FAC124P1A | Installation Instructions - Page 2
    tile way in and repeat on the other side. NOTE: If storm window blocks AC, see FIG. 14. window window Keep a filial grip on the air conditioner, carefully place the unit into the windo_ opening so the bottom of the air conditiouer frame is against the sill (FIG. 6 & FIG. 6A). Carefnlly close the
  • Electrolux FAC124P1A | Installation Instructions - Page 3
    . * Close (slide) side panels into frame. * Keeping a firm grip on air conditioner, raise sash and careflllly "rock" air conditioner backward to drain any condensate water in base of unit. Be careflll not to spill any remaining water while lifting unit from window. Store parts WITH air conditioner.
  • 1
  • 2
  • 3

Installation
Instructions
READ BEFORE
INSTALLING
UNIT
Compact
II Window
Mounting
Y_ur air conditioner
is designed
to install ill standard
double hung windows
with opening
widths of 23 to 36
inches (584 mm to 914 mm) (FIG.
1)
Lower sash must opeu sufficiently
to allow a clear vertical
opening
of 14-1/2 inches
(368 mm). Side
louvers and the
rear
of the AC must
ha_e
clear
air space
to allow
enough
airflow through the condenser;
for
heat
removal.
The rear
of the unit
must be outdoors,
not inside
a
building
or garage.
When
handling
unit,
be careful
to avoid
cuts
from
sharp
metal
edges
and
aluminum
fins on
fl'ont and
rear
coils.
Before
installing
the
unit,
the
Left-Hand
Louver
nmst
be
assembled
to the
unit:
Fig.
1
A,
g.
Careflflly
remove
power
supply
cord
from
air discharge
area
(Fig.
A/.
Careflflly remove the Left-Hand
Louver Assembly
from the
discharge
area. and then remove
it from the plastic bag(Fig. B/.
NOTE:
SAVE CARTON
and these INSTALLATION
INSTRUCTIONS
for flmlre reference. The carton is the
best way to store unit during winter, or when not in use.
C.
With care, pry apart the auger
wheel shaft from the horizontal
louver casing, as shown in Fig.
C,D&
E.
Some assembly
is required.
Please read these instructions
carefally.
Mounting
Hardware
Qty.
7
3/4"screws
lock
frame
sash
lock
TOOLS
NEEDED:
Phillips Screw Driver
Drill (If pilot holes are needed/
..........................
j/
D.
E.
E
O.
Now locate the auger wheel
shaft into the vertical
center
post (Fig. F).
Clip the other end into the
locating
slot.
Now place the horizontal
louver
casing onto the auger wheel
shaft, and snap in place (Fig.
G).
Check
the operation
by moving
the horizontal
louver
up and
dowm
and
then
turn the
auger
wheel
so the
vertical
louvers
rotate.
P/N
66129901166