Epson 1700C Quick Start
Epson 1700C - PowerLite XGA LCD Projector Manual
 |
UPC - 010343858299
View all Epson 1700C manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson 1700C manual content summary:
- Epson 1700C | Quick Start - Page 1
to your notebook 1 Locate the required cables: Power cord VGA computer cable 2 Connect the computer cable to the blue Computer/Component Video port on the projector. Epson® PowerLite® 1700c/1710c Quick Setup 3 Connect the other end to your notebook's video-out or monitor port. NOTE: If - Epson 1700C | Quick Start - Page 2
successful presentations. Quick Setup Epson PowerLite 1700c/1710c Troubleshooting If you see a blank screen... If you see a blank screen or the No signal message after turning on your notebook, check the following: Make sure the Power light on the projector is green and not flashing, and
-
1 -
2
 |
 |
1
Locate the required cables:
2
Connect the computer cable to
the blue
Computer/Component Video
port on the projector.
3
Connect the other end to your notebook’s video-out
or
monitor port.
NOTE:
If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer’s documentation).
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.
1
Turn on your notebook.
2
Open the
A/V Mute
slide.
NOTE:
The slide must be
opened completly.
3
Make sure the
Power
light
is orange and not flashing.
4
Press the
Power
button
to turn on the projector.
S
T
A
R
T
H
E
R
E
T
urn on your equipment
C
onnect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your
User’s Guide
.
Epson
®
PowerLite
®
1700c/1710c
Quick Setup
Power cord
VGA computer cable
1
If you’ve turned on your notebook and you don’t see an image,
press the
Source Search
button on the projector or remote control
to select the image source.
NOTE:
If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
To raise the image, press
the blue foot release
button for the front
adjustable foot and lift
the front. Release the
button to lock the
foot in position.
3
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or
enlarge the image.
4
If your image looks like
or
, you’ve placed the projector off
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
If your image looks like
or
, press the
or
buttons
on the projector to correct it.
A
djust the image
CAUTION:
Before unplugging the projector...
Shut down the projector properly:
1
. Press the
Power
button twice.
2
. When the orange light stops flashing and the projector beeps,
you can unplug the projector.
Turn over
Power light
Power button
Zoom
Focus