Epson 745c Quick Start
Epson 745c - PowerLite XGA LCD Projector Manual
 |
UPC - 010343851207
View all Epson 745c manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson 745c manual content summary:
- Epson 745c | Quick Start - Page 1
EPSON® PowerLite® 745c Quick Setup 1 Turn On Your Equipment 1 Connect the power cord to the back of the projector and plug the other end into an electrical outlet. 2 Remove the lens cover. 3 Remove the battery cover on the remote control. Locate the batteries that came with the projector and insert - Epson 745c | Quick Start - Page 2
the projector's EasyMPTM software and configured your projector and computer before you can project wirelessly. See your User's Guide for instructions. • See your PowerLite 745c User's Guide for instructions. 3 Press the Source Search button on the projector until your computer image is displayed - Epson 745c | Quick Start - Page 3
and the LCD screen. If wireless network from a computer running Windows 98, 2000, Me, XP, or Macintosh OS X 10.2.4 or above. NOTE: You must have already installed the projector's EasyMP (EMP NS Connection) software and configured your projector and computer. See the User's Guide for instructions - Epson 745c | Quick Start - Page 4
-7661 and enter the PIN on the Epson PrivateLine Support card included in your Start Here kit. This service is available 6 AM to 6 PM, Pacific Time, Monday through Friday, for the duration of your warranty period. You may also speak with a projector support specialist by dialing one of these numbers
-
1 -
2 -
3 -
4
 |
 |
EPSON
®
PowerLite
®
745c
Quick Setup
1
Turn On Your Equipment
1
Connect the power cord to the back of the projector and plug the other
end into an electrical outlet.
2
Remove the lens cover.
3
Remove the battery cover on the remote control. Locate the batteries
that came with the projector and insert them as shown. Then replace
the battery cover.
4
To turn the projector on, press the red
Power
button on the
projector or the remote control. The projector beeps once, and the
projector’s
Power
light flashes green and then stays on.
CAUTION: Before unplugging the projector...
Shut the projector down properly:
1.
Press the
Power
button twice. Let the projector cool while the
Power
light flashes orange (about 30 seconds).
2.
Once the light stops flashing and the projector beeps, it’s safe to
unplug the projector.
1
To raise the image, press the blue foot release button for the front
adjustable foot and lift the front. Release the button to lock the
foot in position.
2
Adjust the Image