Epson 8100i User Manual - Lens Options
Epson 8100i - PowerLite XGA LCD Projector Manual
 |
View all Epson 8100i manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson 8100i manual content summary:
- Epson 8100i | User Manual - Lens Options - Page 1
Lens • This long-focal length zoom lens is designed for use only with EPSON multimedia projectors. • It makes it possible to increase the distance between the projector and the screen. • Please read this manual completely before use to assure maximum performance. • Note that illustrations may differ - Epson 8100i | User Manual - Lens Options - Page 2
fall off and cause damage or injury (especially when the projector is ceiling-mounted). 1-2 Check product contents • Make sure that you have all the parts, as shown below, before starting. Rear lens cap Zoom lens Front lens cap User's manual (this document) Screwdriver Used to tighter/remove - Epson 8100i | User Manual - Lens Options - Page 3
amount of dust. Excessive dust inside the lens could cause damage. • Note that the illustrations below may not match your particular projector model. 2-1 Removing the current lens (1) Remove the front case. 1. Remove the two mounting screws, and pull off the front case. Front case Screws (two) 11 - Epson 8100i | User Manual - Lens Options - Page 4
Use the enclosed screwdriver to remove the four mounting screws, and dismount the current lens. Current lens 2-2 Mounting the zoom lens (1) Mounting the zoom lens 1. Remove the rear lens cap. 2. Use the enclosed screwdriver to mount the zoom lens with the four mounting screws. Be sure that the seal - Epson 8100i | User Manual - Lens Options - Page 5
(2) Mounting the front case 1. Set the front case into position and tighten the two screws. This completes installation. • Turn on the power and verify that the projector operates normally. Memo Be sure to remove the front lens cap before turning on the power, or it may melt from the heat. 13 - Epson 8100i | User Manual - Lens Options - Page 6
4. Zoom lens specifications 4-1 Lens specifications 1. Focal length 2. Zoom ratio 3. f number 4. Projection size 5. Mass 68.3 to 116.2 mm 1.7 x 2.14 to 2.98 60 to 300 inches 2100 g 4-2 Appearance with zoom lens mounted About 505mm 15 - Epson 8100i | User Manual - Lens Options - Page 7
Zoom Lens ELPLL03 • This long throw zoom lens is designed for use only with EPSON multimedia projectors. • It makes it possible to increase the distance between the projector and the screen. • Please read this manual completely before use to assure maximum performance. • Note that illustrations - Epson 8100i | User Manual - Lens Options - Page 8
fall off and cause damage or injury (especially when the projector is ceiling-mounted). 1-2 Check product contents • Make sure that you have all the parts, as shown below, before starting. Rear lens cap Zoom lens Front lens cap User's manual (this document) Screwdriver Used to tighter/remove - Epson 8100i | User Manual - Lens Options - Page 9
amount of dust. Excessive dust inside the lens could cause damage. • Note that the illustrations below may not match your particular projector model. 2-1 Remove the current lens (1) Remove the front case. 1. Remove the two mounting screws, and pull off the front case. Front case Screws (two) 11 - Epson 8100i | User Manual - Lens Options - Page 10
Use the enclosed screwdriver to remove the four mounting screws, and dismount the current lens. Current lens 2-2 Mounting the zoom lens (1) Mounting the zoom lens 1. Remove the rear lens cap. 2. Use the enclosed screwdriver to mount the zoom lens with the four mounting screws. Be sure that the seal - Epson 8100i | User Manual - Lens Options - Page 11
(2) Mounting the front case 1. Set the front case into position and tighten the two screws. This completes installation. • Turn on the power and verify that the projector operates normally. Memo Be sure to remove the front lens cap before turning on the power, or it may melt from the heat. 13 - Epson 8100i | User Manual - Lens Options - Page 12
4. Zoom lens specifications 4-1 Lens specifications 1. Focal length 2. Zoom ratio 3. f number 4. Projection size 5. Mass 144.1 to 194.5mm 1.35 x 2.60 to 3.27 80 to 300 inches 2100 g 4-2 Appearance with zoom lens mounted About 505mm 15 - Epson 8100i | User Manual - Lens Options - Page 13
wide Lens • This wide-angle lens is designed for use only on EPSON multimedia projectors. • This lens is designed for use only on rear projection and rear projection box systems. • Please read this manual completely before use to assure maximum performance. • Note that illustrations may differ - Epson 8100i | User Manual - Lens Options - Page 14
(especially when the projector is ceiling-mounted). 1-2 Check product contents • Make sure that you have all the parts, as shown below, before starting. Rear lens cap Zoom lens Screwdriver Front lens cap Used to tighter/remove mounting screws Hex wrench User's manual (this document) Used - Epson 8100i | User Manual - Lens Options - Page 15
amount of dust. Excessive dust inside the lens could cause damage. • Note that the illustrations below may not match your particular projector model. 2-1 Removing the current lens (1) Remove the front case. 1. Remove the two mounting screws, and pull off the front case. Front case Screws (two) 13 - Epson 8100i | User Manual - Lens Options - Page 16
dismount the current lens. Current lens 2-2 Mounting the rear-projection wide-angle lens (1) Mounting the rear-projection wide-angle lens 1. Remove the rear lens cap. 2. Use the enclosed screwdriver to mount the rear projector wide lens with the four mounting screws. Be sure that the seal reading - Epson 8100i | User Manual - Lens Options - Page 17
ring Focus ring Focus ring mounting screws Resolving plane correction ring mounting screws Warning Turn the power only when adjusting the lens. Always disconnect the power cable at other times. When adjusting the lens, take care not to touch any other parts of the projector or lens, as there is - Epson 8100i | User Manual - Lens Options - Page 18
(3) Mounting the front case 1. Set the front case into position and tighten the two screws. This completes installation. • Turn on the power and verify that the projector operates nor- mally. 16 - Epson 8100i | User Manual - Lens Options - Page 19
4. Rear-projection wide-angle lens specifications 4-1 Lens specifications 1. Focal length 2. f number 3. Projection size 4. Mass 27mm 2.3 60 to 100 inches 1600 g 4-2 Appearance with rear projector wide lens mounted About 455mm 18 - Epson 8100i | User Manual - Lens Options - Page 20
lens is designed for use only with EPSON multimedia projectors. • Please read this manual completely before use to assure maximum performance. • Note that illustrations may differ slightly from your actual product. • Specifications are subject to change without notice. Safety Precautions To assure - Epson 8100i | User Manual - Lens Options - Page 21
off and cause damage or injury (especially when the projector is ceiling-mounted). 1-2 Check product contents • Make sure that you have all the parts, as shown below, before starting. Rear lens cap Standard lens Front lens cap User's manual (this document) Screwdriver Used to tighter/remove - Epson 8100i | User Manual - Lens Options - Page 22
amount of dust. Excessive dust inside the lens could cause damage. • Note that the illustrations below may not match your particular projector model. 2-1 Removing the current lens (1) Remove the front case. 1. Remove the two mounting screws, and pull off the front case. Front case Screws (two) 11 - Epson 8100i | User Manual - Lens Options - Page 23
screws, and dismount the current lens. Current lens 2-2 Mounting the standard lens (1) Mounting the standard lens 1. Remove the rear lens cap. 2. Use the enclosed screwdriver to mount the standard lens with the four mounting screws. Be sure that the seal reading "UPPER" is on top. Seal Rear lens - Epson 8100i | User Manual - Lens Options - Page 24
(2) Mounting the front case 1. Set the front case into position and tighten the two screws. This completes installation. • Turn on the power and verify that the projector operates normally. Memo Be sure to remove the front lens cap before turning on the power, or it may melt from the heat. 13 - Epson 8100i | User Manual - Lens Options - Page 25
4. Standard lens specifications 4-1 Lens specifications 1. Focal length 2. Zoom ratio 3. f number 4. Projection size 5. Mass 49.2 to 68.9 mm 1.4 x 1.84 to 2.36 30 to 300 inches 1300 g 4-2 Appearance with standard lens mounted About 475mm 15 - Epson 8100i | User Manual - Lens Options - Page 26
Wide Zoom Lens • This wide zoom lens is designed for use only with EPSON multimedia projectors. • It makes it possible to decrease the distance between the projector and the screen. • Please read this manual completely before use to assure maximum performance. • Note that illustrations may differ - Epson 8100i | User Manual - Lens Options - Page 27
fall off and cause damage or injury (especially when the projector is ceiling-mounted). 1-2 Check product contents • Make sure that you have all the parts, as shown below, before starting. Rear lens cap Zoom lens Front lens cap User's manual (this document) Screwdriver Used to tighter/remove - Epson 8100i | User Manual - Lens Options - Page 28
inside the lens could cause damage. • Note that the illustrations below may not match your particular projector model. 2-1 Removing the current lens (1) Remove the front case. 1. Remove the three mounting screws, and pull off the front case. The two components will separate from each other. Front - Epson 8100i | User Manual - Lens Options - Page 29
Use the enclosed screwdriver to remove the four mounting screws, and dismount the current lens. Current lens 2-2 Mounting the zoom lens (1) Mounting the zoom lens 1. Remove the rear lens cap. 2. Use the enclosed screwdriver to mount the zoom lens with the four mounting screws. Be sure that the seal - Epson 8100i | User Manual - Lens Options - Page 30
(2) Mounting the front case 1. Set the front case into position and tighten the three screws. This completes installation. • Turn on the power and verify that the projector operates normally. Memo • Be sure to remove the front lens cap before turning on the power, or it may melt from the heat. • - Epson 8100i | User Manual - Lens Options - Page 31
4. Zoom lens specifications 4-1 Lens specifications 1. Focal length 2. Zoom ratio 3. f number 4. Projection size 5. Mass 37.9 to 45.5 mm 1.2 x 2.34 to 2.65 60 to 200 inches 2600 g 4-2 Appearance with zoom lens mounted About 480mm 15
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
 |
 |
9
User’s Manual for ELPLL02 Long-Focal Length Zoom Lens
•
This long-focal length zoom lens is designed for use only with EPSON
multimedia projectors.
•
It makes it possible to increase the distance between the projector and
the screen.
•
Please read this manual completely before use to assure maximum per-
formance.
•
Note that illustrations may differ slightly from your actual product.
•
Specifications are subject to change without notice.
Safety Precautions
To assure that this product is used safely, and to help prevent dam-
age or injury, the following symbols are used in the manual. Please
read this manual thoroughly before use to ensure safety and opti-
mum performance.
Warning
Ignoring this warning, or implementing the content in-
correctly, could result in injury or even death.
Memo
Important information, such as additional
explanations, key points to remember, and
things to avoid doing.