Epson Perfection 1670 Photo Notices

Epson Perfection 1670 Photo Manual

Epson Perfection 1670 Photo manual content summary:

  • Epson Perfection 1670 Photo | Notices - Page 1
    warnings and instructions marked on the scanner. Caution: Be sure the AC power cord meets the relevant local safety standards. ■ Place the scanner close enough the AC adapter, power cord, scanner, and transparency unit by yourself except as specifically explained in the scanner's guides. ■ Do not
  • Epson Perfection 1670 Photo | Notices - Page 2
    servicing to qualified service personnel under the following conditions: The power cord or plug is damaged; liquid has entered the scanner or the AC adapter; the scanner or the AC adapter has been dropped or the case damaged; the scanner by the operating instructions.) ■ Unplug the scanner and the AC
  • Epson Perfection 1670 Photo | Notices - Page 3
    unit tested and EPSON Type of Product: Color Image Scanner Model: J141A Warranty Epson America, Inc. Limited Warranty What Is Covered: Epson America, Inc. ("EPSON service, you must provide proof of the date of original purchase. What EPSON Will Do To Correct Problems: Should your EPSON
  • Epson Perfection 1670 Photo | Notices - Page 4
    such as fire, flood, and lightning, improper electrical current, software problems, interaction with non-EPSON products, or service other than by an EPSON Authorized Servicer. If a claimed defect cannot be identified or reproduced in service, you will be held responsible for costs incurred. THE
  • 1
  • 2
  • 3
  • 4

Notices
Important Safety Instructions
Read all these instructions and save them for later reference. Follow all warnings and instructions
marked on the scanner.
Caution:
Be sure the AC power cord meets the relevant local safety standards.
Place the scanner close enough to the computer for the interface cable to reach it easily. Do not
place or store the scanner or the AC adapter outdoors, near excessive dirt or dust, water, heat
sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct
sunlight, strong light sources, or rapid changes in temperature or humidity. Do not use with
wet hands.
Place the scanner and the AC adapter near an electrical outlet where the power cord can be
easily unplugged.
Allow space behind the scanner for the cables, and space above the scanner so that you can raise
the document cover fully.
Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking.
Do not place objects on top of power-supply cords and do not allow the AC adapter or power-
supply cords to be stepped on or run over. Be particularly careful to keep all power-supply
cords straight at the ends and the points where they enter and leave the AC adapter.
Use only the AC adapter model A241B/E that comes with your scanner. Using any other
adapter could cause fire, electrical shock, or injury.
The AC adapter is designed for use with the scanner with which it was included. Do not
attempt to use it with other electronic devices unless specified.
Use only the type of power source indicated on the AC adapter’s label, and always supply
power directly from a standard domestic electrical outlet with the AC power cord that meets
the relevant local safety standards.
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly
switch on and off.
If you use an extension cord with the scanner, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the electrical outlet does not exceed the electrical
outlet’s ampere rating. Do not place multiple loads on the electrical outlet.
Never disassemble, modify, or attempt to repair the AC adapter, power cord, scanner, and
transparency unit by yourself except as specifically explained in the scanner’s guides.
Do not insert objects into any opening as they may touch dangerous voltage points or short out
parts. Beware of electrical shock hazards.