Epson PowerLite 715c Quick Start
Epson PowerLite 715c Manual
 |
View all Epson PowerLite 715c manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson PowerLite 715c manual content summary:
- Epson PowerLite 715c | Quick Start - Page 1
TART S EPSON® PowerLite® 505c/715c Quick Setup HERE Use these instructions to set up your projector. Using a laptop? Follow these instructions to connect your laptop to the projector. To connect other devices, such as a VCR or desktop PC, see your User's Guide. You'll need just two cables: the - Epson PowerLite 715c | Quick Start - Page 2
screen No signal , see the instructions in the box below. 1 Rotate the focus ring to sharpen the image. keystone button lens ring EPSON PowerLite 505c/715c 3 Raise the image as needed. To do this, pull up the blue foot release levers and lift the front of the projector. Once the image is positioned
-
1 -
2
 |
 |
S
T
A
R
T
H
E
R
E
EPSON
®
PowerLite
®
505c/715c
Quick Setup
Connect the power cord to your projector and plug the other end into a grounded outlet.
The
power light turns orange.
3
Connect the other end to your laptop’s video or
monitor
port. If you can’t connect the cable to your PowerBook
®
, you
may need to use an adapter. See your
User’s Guide
for instructions.
1
Press the red
Power
button to turn on the projector. The
power light
flashes green as the projector warms up, and the projection lamp comes on
in about 30 seconds.
2
If you’re using a laptop, turn it on or restart it. (Windows only: If you see
this Add New Hardware screen, click
Cancel
.)
Turn Over
To shut the projector down safely, press the red
Power
button twice. Let the projector
cool while the
power light flashes orange (about a minute). Once the light stops
flashing and stays on, it’s safe to unplug the projector.
Never unplug the projector when the
power light is green or flashing orange.
Use these instructions to
set up your projector.
Plug in your projector
Turn on your equipment
Caution:
Before unplugging the projector...
1
2
Make sure your projector and laptop are turned off.
Connect one end of the computer cable to the
Computer
port on the projector.
Using a laptop?
Follow these instructions to connect your laptop to the projector.
To connect other devices, such as a VCR or desktop PC, see your
User’s Guide
. You’ll need just two cables: the power cord and
computer cable.
tab
power button
Use the tab to rotate the lens ring, which extends the lens.
Then squeeze the tabs to remove the lens cap.
Extend the lens
squeeze here
Presenting without
a computer?
You can use EasyMP™ to run your presentation directly
from the projector. Follow the instructions below to start
the projector. Then see the back of this sheet for more help.
lens cap