Epson PowerLite 81p Lamp Replacement Instructions
Epson PowerLite 81p Manual
View all Epson PowerLite 81p manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson PowerLite 81p manual content summary:
- Epson PowerLite 81p | Lamp Replacement Instructions - Page 1
Update Please substitute the lamp replacement instructions below for the instructions in your Epson® PowerLite® 61p/81p User's Guide: 1. Press the P Power button twice to turn off the projector. When the projector beeps twice, unplug the power cord. 2. If the projector has been on, allow it to - Epson PowerLite 81p | Lamp Replacement Instructions - Page 2
the surface of the projector.) Then slide the cover closed and tighten the screw. 12. Reset the lamp timer as described in the User's Guide. Epson is a registered trademark of Seiko Epson Corporation. PowerLite is a registered trademark of Epson America, Inc. © 2004 Epson America, Inc. 7/04 CPD
Lamp Replacement Update
Please substitute the lamp replacement instructions below for the instructions in your
Epson
®
PowerLite
®
61p/81p User’s Guide
:
1.
Press the
P
Power
button twice to turn off the projector. When the projector beeps twice,
unplug the power cord.
2.
If the projector has been on, allow it to cool down for at least an hour (or until the lamp is cool).
Warning:
Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to
avoid injury.
3.
Use a screwdriver to loosen the screw holding the lamp cover. (The cover is on top of the
projector.)
4.
Slide the cover out, then lift it off.
5.
6.
Use the screwdriver to loosen the two screws holding the lamp in place. You can’t remove them.
7.