Epson Stylus C82 Start Here Card

1

Remove everything from the box.

2

Remove all the blue tape and packing material inside and around the printer.

The tape may be in slightly different places on your printer, so check carefully.

3

Slide the paper support into the

grooves on either side of the sheet

feeder. The paper support should

fit securely.

Unpack

Unpack

Load Ink

Load Ink

1

Lower the printer’s output tray

and open the cover.

2

Shake the package of ink cartridges four or five times. Then remove the cartridges

from the package. (Don’t shake them after removing the packaging.)

3

Lower each ink cartridge into its holder with the green circuit board facing the back.

Then gently push each ink cartridge down until it is firmly seated.

The color of the cartridge label should match the marker on the holder.

4

Press the

ink button and close the printer cover.

The green power light flashes as your printer charges ink for about 90 seconds.

CAUTION: Don’t turn off the printer while the green power light is flashing,

unless the printer hasn’t moved or made any noise for more than 5 minutes.

Connect the Printer

Connect the Printer

Turn over

Printer cables are not included with your printer. You need

only one

of the following cables:

• USB cable (PC or Macintosh

®

)

or

• Parallel cable (PC only).

NOTE: If you have Windows

®

95 or NT 4.x, you must use a parallel cable.

USB Cable Users (PC or Mac)

1

Shut down your computer. In Windows, click

Start

and select your

Shut Down

or

Turn Off

option.

Leave your computer turned off until section 6.

2

Plug the

square end of the cable into the USB port on the side of the printer.

(It’s right above the parallel port.)

3

Plug the

flat end of the cable into your computer’s USB port until it stops.

(You can use any open USB port.)

Parallel Cable Users (PC only)

1

Shut down your computer. Click

Start

and select your

Shut Down

or

Turn Off

option.

Leave your computer turned off until section 6.

2

Plug the end of the cable with the slotted connector into the parallel port on the side

of the printer, then secure it with the wire clips.

3

Plug the end of the cable with the screws on the side into your computer’s

parallel port and secure it.

Power On

Power On

1

Plug the printer’s power cord into a grounded electrical outlet.

2

Press the printer’s

power button until the green power light comes on.

CAUTION: Use only the printer’s

power button to turn the printer on or off.

Power button

Ink button

Don’t touch the

green circuit boards

or remove any labels

Flat end

Square end

Slotted end

End with screws

Paper support

Printer

Ink cartridges

CD-ROM

Manual

1

1

3

3

2

2

4

4

Start

Here

Start

Here

EPSON Stylus

®

C82

EPSON Stylus C82

CPD-14293R1

4025621-01

Epson Stylus C82 Start Here Card

Epson Stylus C82 - Ink Jet Printer Manual

Epson Stylus C82 manual content summary: