Epson Stylus Pro 4880 ColorBurst Edition Quick Reference Guide
Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880 ColorBurst Manual
 |
View all Epson Stylus Pro 4880 ColorBurst Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson Stylus Pro 4880 ColorBurst Edition manual content summary:
- Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 1
Epson Stylus® Pro 4880 QUICK REFERENCE GUIDE - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 2
support on top of the paper tray cover. Note: To use paper with a 2-inch core, remove the gray adapters from the paper stops at each end. See your Printer Guide the secured position and close the roll paper cover. The printer automatically feeds the paper to the printing position. OTHERS Caution: - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 3
printer is on and roll paper is not loaded for printing. 1 If your paper size is A3 or larger, pull out the paper tray and cover. 5 Load the sheets in the portrait guide roller and slide the edge guide all the way to the left. 6 Adjust the paper tray and edge guide the paper guide roller, adjust the - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 4
the printer for feeding the paper. Note: You can also load paper through the rear manual feed slot. See your Printer Guide for details. 1 Make sure the printer is 7 Return the paper lever to the secured position. The printer grabs the paper and feeds it into printing position. 4 Insert the sheet face- - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 5
confirm the setting. 7 Press the II pause button. Note: You can manually run a cleaning cycle by pressing the Menu button and holding it for more sure the printer is turned on. Then load sheets of Epson Ultra Premium Photo Paper Luster if you're printing with Photo Black ink, or Epson Ultra Premium - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 6
Cartridges Before you begin a large print job, you should any combination of 110 ml and 220 ml cartridges. Epson UltraChrome K3TM withVivid Magenta ink 110 ml 220 ml Black T613800 T614800 3 Remove the expended ink cartridge from the printer. Warning: Do not shake the expended cartridge, or ink - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 7
PRINTER STATUS. 2 Press Menu, then press the button until you see SERVICE LIFE. 3 Press the Menu button, then press the button until you see CUTTER. E*****F indicates a new media: • Fine art paper (such as Epson UltraSmooth®, Textured, or Velvet) • Canvas • Vinyl • Matte board • - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 8
Replacing Printer Parts (continued) 4 Hold down the side pin, as shown, then turn the the tank, or ink may spill out. 2 Place the used tank in the plastic bag included with the new tank. 3 Insert the new tank. 7 Hold down its side pin and secure it with the latch. Note: If you removed any 220 - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 9
messages For a complete list of error messages, see your Printer Guide. Message INK LOW Light Ink light flashing REPLACE INK CRTG Ink the released position. Move the paper lever to the secured position. The printer cannot detect the paper. Make sure paper is loaded correctly and the paper - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 10
) 276-1305. Go to epson.com/support to download drivers and firmware, access product documentation and troubleshooting, and get technical advice through e-mail. Contact the RIP manufacturer. Epson and Epson Stylus are registered trademarks and Epson UltraChrome K3 and Epson Exceed Your Vision are - Epson Stylus Pro 4880 ColorBurst Edition | Quick Reference Guide - Page 11
Control Panel Lights and Buttons Power button Pause light and button Hold for 3 seconds to cancel a print job or reset the printer. Ink light Left arrow or Paper Source button Hold for 3 seconds to cut roll paper after printing. Menu button Hold for 3 seconds to clean the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
 |
 |
Epson Stylus
®
Pro 4880
QUICK REFERENCE GUIDE