Epson TM-L90 User Manual
Epson TM-L90 Manual
 |
View all Epson TM-L90 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson TM-L90 manual content summary:
- Epson TM-L90 | User Manual - Page 1
User's Manual M00075800EN - Epson TM-L90 | User Manual - Page 2
cables other than those designated as Epson approved products. EPSON is a registered trademark of Seiko Epson Corporation in Japan and other countries/regions. NOTICE: The contents of this manual are subject to change without notice. Copyright © 2013 by Seiko Epson Corporation 2 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 3
unplug the power cord immediately, and then contact your dealer or a Seiko Epson service center for advice. Continued usage may lead to fire. Do not use connector; otherwise, the printer and the telephone line may be damaged. Use a shield cable for the drawer connector cable. TM-L90 User's Manual 3 - Epson TM-L90 | User Manual - Page 4
paper To ensure safety, unplug this product before leaving it unused for an extended period. Caution Labels The caution labels on the product indicate the following precautions. CAUTION: The thermal make your own judgment on this product's suitability after a full evaluation. 4 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 5
are damaged, contact your dealer. ❏ Printer ❏ Power switch cover ❏ Wire saddle ❏ Roll paper spacer ❏ Screw for installation of the roll paper spacer ❏ Paper exit guide for horizontal installation ❏ Start Here ❏ Manual CD ❏ Roll paper* ❏ Control panel label for horizontal installation* ❏ AC adapter - Epson TM-L90 | User Manual - Page 6
Panel FEED button Feeds the roll paper. PAPER OUT LED Lights when roll paper is out. ERROR LED Off when the printer is online, lights when the printer is offline, and flashes when an error occurs. POWER LED Lights when the power is on, and is off when the power is off. 6 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 7
such as a ballpoint pen in the holes in the power switch cover. Power switch cover WARNING: If an accident occurs with the power switch cover attached, unplug the power cord immediately. Continued use may cause fire or shock. CAUTION: Do not remove the power switch soft cover. TM-L90 User's Manual 7 - Epson TM-L90 | User Manual - Page 8
to move the sensor in the direction of the arrow in illustration until the sensor comes out from another hole near the bottom of the printer. Lever Screw Near-end sensor Hole 4. Tighten the screw and make sure the lever moves smoothly. 8 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 9
61 to 70 mm wide, break two tabs off the back of the roll paper spacer. (You can still use widths from 38 mm to 60 mm with the roll paper spacer with the tabs broken off.) Follow the steps below to attach the roll paper spacer. Tabs 1. Open the roll paper cover. TM-L90 User's Manual 9 - Epson TM-L90 | User Manual - Page 10
that the roll paper spacer slides smoothly to the left and right. 4. Slide the roll paper spacer to the appropriate width. You can use the ruler printed inside the printer, aligning the inside edge of the spacer with the desired measurement. Hook Shaft Inside edge Ruler 10 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 11
the TM-L90 Technical Reference Guide for details. See the TM-L90 Technical Reference Guide also for how to use the product and detailed product specifications. Go to http://www.epson.jp/dl-sd to download the memory switch setting utility and TM-L90 Technical Reference Guide. TM-L90 User's Manual 11 - Epson TM-L90 | User Manual - Page 12
cover. 2. Break off by hand any of the three portions indicated by circles in illustration to pass the cables through. 3. Connect the cables to the printer. 4. Attach the cover while passing the cables through the holes. 12 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 13
cut by the autocutter from falling inside the printer. Paper exit guide Note: When using a roll paper that has a paper core smaller than the specified (internal diameter: 25.4 mm {1"}, external diameter: 31.4 mm {1.24"}), do not use the paper guide, or paper jam may result. TM-L90 User's Manual 13 - Epson TM-L90 | User Manual - Page 14
Installing the Roll Paper 1. Lift the cover open lever and open the roll paper cover. 2. Remove the used roll paper core, if any. 3. Install the roll paper in the correct direction. 14 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 15
4. Pull out some roll paper, so that the paper is set between the paper guides. Paper guides 5. Close the roll paper cover. TM-L90 User's Manual 15 - Epson TM-L90 | User Manual - Page 16
6. Tear off the roll paper. Note: Be sure to use the roll paper that meets the specifications. 16 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 17
and open the printer cover. Clean the thermal elements of the thermal head with a cotton swab moistened with an alcohol solvent (ethanol or IPA). Thermal head Epson recommends cleaning the thermal head periodically (generally every 3 months) to maintain receipt print quality. TM-L90 User's Manual 17 - Epson TM-L90 | User Manual - Page 18
. If the roll paper cover will not open, see the section below. If glue or another foreign substance is present on the autocutter blade, platen roller, or the paper path, a paper jam is likely to occur. See "Cleaning the Thermal Head" on page 17 for cleaning instructions. 18 TM-L90 User's Manual - Epson TM-L90 | User Manual - Page 19
sides of the printer, and lift the cover in the direction of the arrow in illustration to remove it. Slot 3. Turn the knob in the direction of the arrow in illustration, by using a ballpoint pen or tweezers, until you see a triangle mark in the opening. Knob Triangle mark TM-L90 User's Manual 19 - Epson TM-L90 | User Manual - Page 20
TM-L90 Specifications . Print method Thermal line printing Dot density 203 dpi × 203 dpi [dots per 25.4 mm {1"}] Print width 72 mm {2.84"}, 576 dot positions (receipt paper roll with 80 mm width) Paper dimensions 37.5 ± 0.5 ~ 69.5 ± 0.5 mm, 79.5 ± 0.5 ( max roll diameter 90 mm) Interface (
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
User’s Manual
M00075800EN