Epson WorkForce 30 Start Here
Epson WorkForce 30 - Ink Jet Printer Manual
UPC - 010343868267
View all Epson WorkForce 30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson WorkForce 30 manual content summary:
- Epson WorkForce 30 | Start Here - Page 1
Start Here Please read these instructions before using the printer. 1 Unpack Caution: Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability. If anything is missing, contact Epson® as described on the back of this sheet. 2 Turn - Epson WorkForce 30 | Start Here - Page 2
the ink cartridges. 1 Lift up the printer cover. 2 Open the cartridge cover. 3 S hake the ink cartridges, then unpack them. 4 Remove only the yellow tape from each cartridge. Caution: Don't remove any other seals from the cartridges. 5 Insert the cartridges in the holder for each color. - Epson WorkForce 30 | Start Here - Page 3
the ink cartridge cover and press it down until it clicks. 8 Close the printer cover. 9 Press the ink button to charge ink. Charging takes about 2.5 minutes. Caution: Don't turn off the printer while the power light is flashing or you'll waste ink. 4 Load paper 1 Open the paper support. - Epson WorkForce 30 | Start Here - Page 4
2 Open the output tray and pull out the extensions. 3 Squeeze the edge guide and slide it left. 4 Load paper against the right edge guide and behind the tab, with the printable side face up. Note: Don't load the paper sideways; always load it short edge first. 5 Slide the edge guide over. - Epson WorkForce 30 | Start Here - Page 5
port on your computer. Note: If installation doesn't continue after a moment, make sure you securely connected and turned on the printer. 6 When you're done, remove the CD and restart your computer. You're ready to print! See your Quick Guide or online Epson Information Center for instructions. - Epson WorkForce 30 | Start Here - Page 6
Macintosh® 1 Make sure the printer is NOT CONNECTED to your computer. 2 Insert the WorkForce 30 Series software CD. 3 Double-click the Epson icon. 4 Click Install and follow the on-screen instructions. 5 When prompted, connect the USB cable. Use any open USB port on your computer. If you're using - Epson WorkForce 30 | Start Here - Page 7
contact Epson as described in "Any Questions?". • Turn off the printer, then make sure the ink cartridges are inserted completely and the ink cartridge cover is closed completely. Wait a moment, then turn the printer back on to clear the error. You're having problems installing the printer software - Epson WorkForce 30 | Start Here - Page 8
Capacity color ink cartridges are available only online; visit www.epson.com/highcapacity (U.S. sales) or www.epson.ca (Canadian sales). Epson is a registered trademark, Epson Exceed Your Vision is a registered logomark, and Supplies Central is a service mark of Seiko Epson Corporation. DURABrite
Caution:
Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
If anything is missing, contact Epson
®
as described on the back of this sheet.
Unpack
1
Start Here
Please read these instructions before using the printer.
1
Connect the power cable.
2
Press the
power button.
Turn on the printer
2