Eureka Comfort Clean 4236AZ Quick Start Guide

Eureka Comfort Clean 4236AZ Manual

Eureka Comfort Clean 4236AZ manual content summary:

  • Eureka Comfort Clean 4236AZ | Quick Start Guide - Page 1
    4230 Series QUICK START GUIDE Thank you for purchasing your new Eureka vacuum! Before returning, call Eureka Customer Service HELPLINE 1-800-282-2886 8 a.m. to 7:30 p.m. (CST), Monday - Friday 10 a.m. to 6:30 p.m. (CST), Saturday - Sunday www.eureka.com 1STEP 2STEP What's in the carton
  • 1

What’s in the carton
STEP
1
1
Easy assembly
Slide upper housing onto
vacuum body. Fasten with
2 medium screws (A).
Insert handle until mark
aligns with top of housing.
Fasten with 1 long screw (B).
Slide tool caddy onto housing.
Sides will click into position.
Snap hose retainer onto back
of vacuum body. Fasten
with 1 short screw (C).
STEP
2
2
Get ready to vacuum
A
A
Step on power switch to turn
on; step on again to turn off.
Step on handle release to
lower handle into position.
Push down release button and
pull out handle to desired height.
Pull out full length of cord;
push into cord retainer.
For accessories: Loosen end of
wand, pull out and attach tool.
Adjust height using foot for
carpet or bare floors.
Lift latch to remove dust cup.
Empty after each use.
Press button to rewind cord.
STEP
3
3
Use a Phillips
screwdriver.
PROBLEM SOLVING
Refer to Owner’s Guide.
MAINTENANCE SCHEDULE
Refer to back of dust cup or Owner’s Guide.
QUICK START GUIDE
4230 Series
Before returning, call
Eureka Customer Service
HELPLINE
1-800-282-2886
8 a.m. to 7:30 p.m. (CST), Monday - Friday
10 a.m. to 6:30 p.m. (CST), Saturday - Sunday
www.eureka.com
T
h
a
n
k
y
o
u
f
o
r
p
u
r
c
h
a
s
i
n
g
y
o
u
r
n
e
w
E
u
r
e
k
a
v
a
c
u
u
m
!
Position hose connector
on back of vacuum. Fasten
with 1 short screw (C).
Pull out bottom of hose
retainer and position hose.
Place hose over hook on
handle. Secure in sides of
tool caddy.
Push end of wand into wand
retainer on side of vacuum.
Place dust cup on body and
snap into place.
Place dusting brush and
crevice tool on tool caddy.
Pull up plug and slip into slot
on tool caddy.
Snap Power Paw
®
into clip on front.
A
B
C
Vacuum body
Upper housing
Dust cup
Telescoping
handle
Important Safeguards
Dusting
brush
Crevice
tool
Tool caddy
Hose retainer
5 screws: 2 medium (A),
1 long (B), 2 short (C)
Hose &
telescoping wand
REGISTRATION
OWNER’S
GUIDE
Stair Hose
SPECIAL FEATURES
Available on some models
Power Paw
®
!
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
Moving parts! Assemble the vacuum cleaner before using.
Bare Floor Nozzle
and Wand
B
C
A
A
C