Fisher and Paykel CMOTTK-FP Trim intall guide for CMOS-24SS-2 (English)
Fisher and Paykel CMOTTK-FP Manual
View all Fisher and Paykel CMOTTK-FP manuals
Add to My Manuals
Save this manual to your list of manuals |
Fisher and Paykel CMOTTK-FP manual content summary:
- Fisher and Paykel CMOTTK-FP | Trim intall guide for CMOS-24SS-2 (English) - Page 1
FISHER & PAYKEL CONVECTION MICROWAVE TRIM KIT INSTALLATION INSTRUCTIONS Before you begin, read these instructions completely and carefully. Getting Started s Remove packaging Contents Part Description Trim Assembly Base Rear Duct Forward Duct Foam Tape Mounting Bracket (L/R) Sheet Metal Screws - Fisher and Paykel CMOTTK-FP | Trim intall guide for CMOS-24SS-2 (English) - Page 2
and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the recommendations in the Microwave Installation/ Use & Care Manual. 2. Add adequate platform base support in the bottom of the cabinet for trim kit base to rest on. 3. Mark a centerline on the front edge of the cabinet - Fisher and Paykel CMOTTK-FP | Trim intall guide for CMOS-24SS-2 (English) - Page 3
SCREW HOLE REAR CONVECTION DUCT FOAM TAPE ON THIS FLANGE FORWARD CONVECTION DUCT FOAM TAPE ON THIS FLANGE CABINET INSERT 4 MOUNTING BRACKET SUPPORT TRIM KIT ASSEMBLY 25 3/4" +1/16"-0" FOAM TAPE ON THIS FLANGE HORIZONTAL CLIP ORIENTATION ON MOUNTING BRACKET 1/8" HOLE FOR MOUNTING SCREW TOP - Fisher and Paykel CMOTTK-FP | Trim intall guide for CMOS-24SS-2 (English) - Page 4
tP/N 242602 Rev. A 02/09
FISHER & PAYKEL CONVECTION MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before installing trim kit, install the convection duct as follows:
1.
Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied
(Fig. 01).
2.
Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).
3.
Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the Microwave
(Fig. 03).
4.
Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).
Before you begin, read these instructions completely and carefully.
Getting Started
■
Remove packaging
Contents
Tools Required
Part Description
Qty
Trim Assembly
1
Base
1
Rear
Duct
1
Forward Duct
1
Foam Tape
2 ft
Mounting Bracket (L/R)
2
Sheet Metal Screws
14
1/8” Drill
#2 Phillip Screwdriver
Fig. 01
Fig. 02
Fig. 03
Fig. 04
4 Screws
Foam Tape
Foam
Tape