Fisher and Paykel HC24PCX1 Installation Guide
Fisher and Paykel HC24PCX1 Manual
 |
View all Fisher and Paykel HC24PCX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Fisher and Paykel HC24PCX1 manual content summary:
- Fisher and Paykel HC24PCX1 | Installation Guide - Page 1
WALL RANGE HOOD, CHIMNEY PYRAMID CLASSIC HC24PCX1, HC30PCX1, HC30PCB1, HC30PCR1, HC30PCW1, HC36PCX1, HC36PCB1, HC36PCR1 & HC36PCW1 INSTALLATION GUIDE US CA - Fisher and Paykel HC24PCX1 | Installation Guide - Page 2
- Fisher and Paykel HC24PCX1 | Installation Guide - Page 3
CONTENTS Safety and warnings Parts supplied Prior to installation Product dimensions - 24" models Product dimensions - 30" models Product dimensions - 36" models Installation height Attachment dimensions Venting options Prepare range hood Attach brackets and mounting screws Hang range hood - Fisher and Paykel HC24PCX1 | Installation Guide - Page 4
the following: General z Please read the entire set of instructions before installing or using this appliance. z Please make this installing the appliance. z Always switch the power off prior to installation, servicing or cleaning of the appliance. z The room must have adequate ventilation when - Fisher and Paykel HC24PCX1 | Installation Guide - Page 5
only by a qualified person according to these installation instructions and in compliance with any applicable local building and this equipment is damaged, it must only be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. z Ducting accessories - Fisher and Paykel HC24PCX1 | Installation Guide - Page 6
WALL RANGE HOOD, CHIMNEY PYRAMID CLASSIC HC24PCX1, HC30PCX1, HC30PCB1, HC30PCR1, HC30PCW1, HC36PCX1, HC36PCB1, HC36PCR1 & HC36PCW1 INSTALLATION GUIDE US CA Installation guide (1) Chimney (1) Upper chimney (1) Power connection box (1) 3/8" (10 mm) Self tapping screw (4) Upper chimney bracket - Fisher and Paykel HC24PCX1 | Installation Guide - Page 7
PRIOR TO INSTALLATION EN The manufacturer is not liable for any damage caused by not following these instructions. z Unpack the range hood. z Ensure the voltage (V) and the frequency (Hz) indicated on the rating plate match the voltage and frequency of the installation site. z - Fisher and Paykel HC24PCX1 | Installation Guide - Page 8
PRODUCT DIMENSIONS - 24" MODELS j d i UL connection box h PLAN g f A b PROFILE 8 e c FRONT l k BOTTOM - Fisher and Paykel HC24PCX1 | Installation Guide - Page 9
PRODUCT DIMENSIONS - 24" MODELS EN PRODUCT DIMENSIONS A Maximum overall height of product B Minimum overall height of product C Overall width of product D Overall depth of product E Height of product F Width of chimney G Depth of chimney H Distance from center of ducting outlet to back of product - Fisher and Paykel HC24PCX1 | Installation Guide - Page 10
PRODUCT DIMENSIONS - 30" MODELS j d i UL connection box h PLAN g f A b PROFILE 10 e c FRONT l k BOTTOM - Fisher and Paykel HC24PCX1 | Installation Guide - Page 11
PRODUCT DIMENSIONS - 30" MODELS EN PRODUCT DIMENSIONS A Maximum overall height of product B Minimum overall height of product C Overall width of product D Overall depth of product E Height of product F Width of chimney G Depth of chimney H Distance from center of ducting outlet to back of product - Fisher and Paykel HC24PCX1 | Installation Guide - Page 12
PRODUCT DIMENSIONS - 36" MODELS j d i UL connection box h PLAN g f A b PROFILE 12 e c FRONT l k BOTTOM - Fisher and Paykel HC24PCX1 | Installation Guide - Page 13
PRODUCT DIMENSIONS - 36" MODELS EN PRODUCT DIMENSIONS A Maximum overall height of product B Minimum overall height of product C Overall width of product D Overall depth of product E Height of product F Width of chimney G Depth of chimney H Distance from center of ducting outlet to back of product - Fisher and Paykel HC24PCX1 | Installation Guide - Page 14
indicated in the table above. Minimum installation height may be greater if required by the cooktop, refer to your cooktop installation instructions. Installation at the minimum height will improve the efficiency of capturing cooking odours, grease and smoke. Installation above the minimum height - Fisher and Paykel HC24PCX1 | Installation Guide - Page 15
ATTACHMENT DIMENSIONS EN G H E C F D B A Upper chimney bracket attachment points Chimney bracket attachment points Upper range hood hood attachment points Lower range hood attachment points ATTACHMENT DIMENSIONS A Lower range hood attachment point width B Lower range hood attachment point height - Fisher and Paykel HC24PCX1 | Installation Guide - Page 16
VENTING OPTIONS Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. Ducted It is recommended that 8" (203mm) diameter, rigid or semi-rigid ducting is used. This will require a 8 1/4" (210mm) (min) round hole in the ceiling or - Fisher and Paykel HC24PCX1 | Installation Guide - Page 17
ELECTRICIAL REQUIREMENTS EN Rating plate location Before connecting the range hood to the power supply, ensure the voltage and frequency indicated on the rating plate match that of the installation location. MODEL HC24, HC30, HC36 FREQUENCY 60 Hz VOLTAGE 120 V 17 - Fisher and Paykel HC24PCX1 | Installation Guide - Page 18
PREPARE RANGE HOOD Warning: Failure to install the screws or fixing device in accordance with these instructions may result in an electrical hazards. Remove the filters -pull the catch and tilt the filter downwards until it disengages from the supports. 1 18 - Fisher and Paykel HC24PCX1 | Installation Guide - Page 19
ATTACH BRACKETS AND MOUNTING SCREWS EN Temporarily mark the height of the bottom of the range hood and the 1 centre of the cooktop on the wall according to the information provided in 'Installation Height'. Attach the chimney bracket and upper chimney bracket (if using 2 the upper chimney - Fisher and Paykel HC24PCX1 | Installation Guide - Page 20
HANG RANGE HOOD Hang the range hood off the upper 1 range hood mounting screws with 1/16" (2mm) gap. Hang off the keyhole attachment points on the back of the range hood then tighten the screws. 2 3 20 Attach the lower range hood mounting screws to fix the range hood to the wall. Refit the - Fisher and Paykel HC24PCX1 | Installation Guide - Page 21
ELECTRICAL CONNECTION EN 1 Run three wires from the power connection box on the rangehood to the power point. 2 Two wires for the power supply and one for the ground wire. Open the power connection box on the range hood and secure the power conductor with a strain relief (not included). 3 Connect - Fisher and Paykel HC24PCX1 | Installation Guide - Page 22
ATTACH CHIMNEY 1 Bend the tabs on the chimney. REAR VIEW Place chimney around the range 2 hood chassis and hang off the chimney bracket. 3 22 Extend the upper chimney and attach to the upper chimney bracket with 10mm screws. - Fisher and Paykel HC24PCX1 | Installation Guide - Page 23
Power mains switch is accessible to the customer and switched on. … Operation of the product has been tested, refer to user guide. Complete and keep for safe reference: Model Serial no. Purchase date Purchaser Dealer address Installer's name Installer's signature Installation company Installation - Fisher and Paykel HC24PCX1 | Installation Guide - Page 24
may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
INSTALLATION GUIDE
US CA
WALL RANGE HOOD, CHIMNEY PYRAMID
CLASSIC
HC24PCX1, HC30PCX1, HC30PCB1, HC30PCR1, HC30PCW1, HC36PCX1,
HC36PCB1, HC36PCR1 & HC36PCW1