Foxconn G31MX-K 2.0 English Manual. - Page 26
USB device wake-up Jumper: USBPW1357_1/ USBPW0246_1
View all Foxconn G31MX-K 2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
2 WARNING! ■ Disconnect the power cable before adjusting the jumper settings. ■ Do not clear the CMOS while the system is turned on. USB device wake-up Jumper: USBPW1357_1/ USBPW0246_1 1. Set the jumper to pins 1-2 (+5V) to wake up the computer from S1 sleep mode using the connected USB devices. 2. Set the jumper to pins 2-3 (+5VSB) to wake up the computer from S3 and S4 sleep modes using the connected USB devices. At the same time, a corresponding setting must be set in BIOS as below: Set "CMOS Setup" -> "Power Management Setup" ->"Power Management Events" -> "USB KB Wake-Up From S3" to "Enabled". 1 +5V 2 (Default) 3 1 +5VSB 2 3 USBPW1357_1/ USBPW0246_1 ! ■ USBPW0246_1 is for the internal USB connectors, USBPW1357_1 is for the rear USB ports. ■ The USB device wake-up feature requires a power supply that can provide 500mA on +5VSB lead for each USB port; otherwise, the system will not power up. ■ The total current consumed must not exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode. CAUTION 19