Frigidaire DGEF3031KB Installation Instructions

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Clearances and Dimensions

1.

Provide adequate clearances between the range and adjacent combustible surfaces.

2.

Location—Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor.

3.

Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level.

*30" MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE

BOTTOM OF AN UNPROTECTED WOOD OR

METAL CABINET; OR 24" MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT LESS THAN 1/4" FLAME

RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015" STAINLESS STEEL, 0.024" ALUMINUM OR

0.020" COPPER. 0" CLEARANCE IS THE MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED

ABOVE TO PREVENT PROPERTY DAMAGE, POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS.

TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE LOCATED ABOVE

THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN BE REDUCED BY INSTALLING A

RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" BEYOND THE BOTTOM OF THE CABINETS.

p/n 316454912 rev C

Fig. 1

Fig. 2

Fig. 3

Important Notes to the Consumer:

Keep these instructions with your owner's guide for future

reference.

•

As when using any appliance generating heat, there are

certain safety precautions you should follow. These are

listed in the

Use & Care Guide, read it carefully.

•

Be sure your range is installed and grounded properly by a

qualified installer or service technician.

•

Make sure the wall coverings around the range can

withstand the heat generated by the range.

•

To eliminate the need to reach over the surface elements,

cabinet storage space above the elements should be

avoided.

IMPORTANT SAFETY INSTRUCTIONS

INSTALLATION INSTRUCTIONS FOR FREESTANDING ELECTRIC RANGE

1

Español - Páginas 5-8

25-3/4”

49”

48”

29 1/4” with

door handle

maximum

door open

maximum

•

Ensure the anti-tip device is re-engaged when the range

is moved to floor or wall.

•

Do not operate the range without the anti-tip device in

place and engaged.

•

Failure to follow these instructions can result in death or

serious burns to children and adults.

Tip Over Hazard

To check if the anti-tip bracket is installed properly, use both

arms and grasp the rear edge of range back. Carefully

attempt to tilt range forward. When properly installed, the

range should not tilt forward.

Refer to the anti-tip bracket

installation instructions

supplied with your range for proper installation.

Range

leveling leg

Anti-Tip

bracket

•

A child or adult can tip the range and

be killed.

•

Verify the anti-tip device has been

installed to floor or wall.

If the information in this manual is not followed

exactly, a fire or electrical shock may result causing property

damage, personal injury or death.

Important Notes to the Installer:

•

Read all instructions contained in these installation

instructions before installing range.

•

Remove all packing material from the oven compartments

before connecting the gas & electrical supply to the range.

•

Observe all governing codes and ordinances.

•

Be sure to leave these instructions with the consumer.