Frigidaire FAC124P1A Installation Instructions

Frigidaire FAC124P1A - Compact II 12,000-BTU Room Air Conditioner Manual

Get Frigidaire FAC124P1A - Compact II 12,000-BTU Room Air Conditioner PDF manuals and user guides
UPC - 012505271021
View all Frigidaire FAC124P1A manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FAC124P1A manual content summary:

  • Frigidaire FAC124P1A | Installation Instructions - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT Compact II Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) Lower sash must open sufficiently to allow a clear vertical opening of
  • Frigidaire FAC124P1A | Installation Instructions - Page 2
    blocks AC, see FIG. 14. 2 Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6 & FIG. 6A). Carefully close the window behind the top rail of the unit. FIG. 3A B. Slide the free end
  • Frigidaire FAC124P1A | Installation Instructions - Page 3
    upper and lower sashes (FIG. 13). FIG. 13 FIG. 9 5 Drive 1/2" (13 mm) locking screws through frame holes into window sash (FIG. 10/11). FIG. 10 FIG. 11 If AC is Blocked by Storm Window Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed. FIG. 14 SASH STORM
  • Frigidaire FAC124P1A | Installation Instructions - Page 4
    Instrucciones de Instalación Leerlas antes de instalar la unidad Montaje de Compact II Window Su aire acondicionado (AA) es diseñado para instalarse en las ventanas de guillotina estándar con el ancho de 23 a 36 pulgadas (584 mm a 914 mm) (
  • Frigidaire FAC124P1A | Installation Instructions - Page 5
    la ventana anti-tempestad bloquee el acondicionador de aire, Ver figura 14. 2 Agarre firmemente el aire acondicionado y colóquelo en la ventana de 4. Deslize el marco. Asegúrese de dejar sufuciente espacio para poner la parte superior e inferior del marco en los carriles del gabinete. FIG. 3B FIG
  • Frigidaire FAC124P1A | Installation Instructions - Page 6
    el espacio entre el marco superior y el inferior (Fig.13) FIG. 13 FIG. 9 5 Talare los tornillios de 1/2" (13mm grueso de tabla requerido para declive adecuado hacia parte trasera a lo largo ede todo el Figura 12. FIG. 12 Como remover su aire acondicionado de la ventana Apagar el aire acondicionado
  • Frigidaire FAC124P1A | Installation Instructions - Page 7
    Instructions d'Installation VEUILLEZ LIRE CE MANUEL AVANT L'INSTALLATION Installation pour la fenêtre Compact II Votre climatiseur est conçu pour être install ère du climatiseur doivent laisser un espace suffisant pour un flux d'air à travers le condensateur, et l'évacuation de la chaleur. Le derri
  • Frigidaire FAC124P1A | Installation Instructions - Page 8
    , sur un banc ou sur une table. Il y a à droite et à gauche un panneau de filtration- Soyez sûre d'utiliser le panneau correcte pour chaque côté. Une fois installée, la bride pour sécuriser le panneau en place au bord de la fenêtre sera vers l'intérieur de la chambre. A. Maintenez le panneau accord
  • Frigidaire FAC124P1A | Installation Instructions - Page 9
    13 mm) les vis de serrure à travers les trous du cadre dans le vantail de fenêtre. FIG. 10 Si le Climatiseur est Bloqué par la Contre-fenêtre Ajoutez du bois comme indiqué sur la FIG. 14, ou bien enlever la contre-fenêtre avant d'installer (19 mm) (FIG. 12). FIG. 12 Enlevez le Climatiseur de la
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
1
Installation Instructions
READ BEFORE INSTALLING UNIT
Compact II Window Mounting
Your air conditioner is designed to install in standard
double hung windows with opening widths of 2
3
to 36
inches (5
84
mm to 914 mm) (FIG. 1)
Lower sash must open sufficiently to allow a clear vertical
opening of 14-1/2 inches (368 mm).
Side louvers and the
rear of the AC must have clear air space to allow
enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a
building or garage.
TOOLS NEEDED:
Phillips Screw Driver
Drill (If pilot holes are needed)
Qty.
3/4"screws
7
lock frame
2
sash lock
1
Mounting Hardware
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is the
best way to store unit during winter, or when not in use.
Some assembly is required. Please read these instructions
carefully.
CAUTION
P/N
66129901166