Frigidaire FAK085R7V Installation Instructions (All Languages)
Frigidaire FAK085R7V - Slider/Casemen Room Air Conditioner Manual
 |
UPC - 012505272028
View all Frigidaire FAK085R7V manuals
Add to My Manuals
Save this manual to your list of manuals |
Frigidaire FAK085R7V manual content summary:
- Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 1
- Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 2
Installation Tips For wood-frame casement windows: It may be necessary to construct a frame, using at least 1-inch thick wood, with a 15-1/2-inch wide opening. For brick or cement building construction: It may be necessary to put a wood stool strip under AC, for mounting purposes. Tools Required - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 3
the necessary parts. Installation kit contents: 1. Platform (1) 2. Support brace (1) mounting platform. In some cases, due to a variety of stop and track arrangements, the above dimensions may vary slightly. If necessary, installation can be made by alternating window jambs. (See Alternate Window - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 4
difficult to move air around corners. Also, choose a window that is within 6 feet of an electrical outlet. (See Meeting Electrical Requirements/Receptacle wiring needs.) Do not use an extension cord. 6 foot power cord reach Installing Unit in a Sliding Window 1. Attach support brace to platform - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 5
, and attach it to window jamb. Use appropriate length screws (Items 9-11 in Preparing For Installation). 7. Adjust platform assembly so that outside edge is 3/16-inch lower than inside edge, as shown right. This ensures proper water drainage from the air conditioner. 8. Level platform assembly from - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 6
and lift up to release it from the case. 4. Then release the electrical coupler plug. NOTE: DO NOT push or pull air direction louvers. 15. Place AC in window opening. As shown right, it should sit on platform assembly so that window panel frame, and cabinet side channels are against top and side - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 7
the air conditioner (either in or out) after completing the installation. Slide inner window sash firmly against Cabinet. Install safety replace the retaining screws that holds the panel in place. Do not push or pull the front panel louvers. Alternate Window Jamb Applications To install in windows - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 8
the pivots in the future. To avoid crank handle and window clearance problems, the unit can be installed in a stationary sash section. However, the horizontal mullion and the 2 glass panels must be removed before installation. 1. Attach support brace to platform as shown. Use the adjustment bolt and - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 9
panel frame with the smooth side to the outside. Slide the panel frame assembly into the side channels of the air conditioner cabinet. Make sure the plastic window panel is firmly enclosed on all sides by the retainer grooves. (continued) Measure distance and subtract 20 /5 8 inches. Panel - Frigidaire FAK085R7V | Installation Instructions (All Languages) - Page 10
and lift up to release it from the case. 4. Then release the electrical coupler plug. NOTE: DO NOT push or pull air direction louvers. Apply weather seal to side channels just below edge of panel frame. 13. Place the air conditioner in the window opening as shown to the right. It should sit on the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
 |
 |
